Electircal issue with 2003 liberty rear wiper

[PDF]Wiring Diagram.pdf - Ken Gilbert

ken-gilbert.com/wrx/mans/99.../Wiring%20Diagram.pdf

Each connector number shown in the wiring dia- ... Rear defogger cord (Ground). Fuel tank cord,. Roof cord, ... circuit. Then check the switch, relay, fuse, ground, etc. 4. .....Rear wiper motor. Rear wiper ... License plate light RH. Tail light LH.

#? license plate light - Circuit Wiring Diagrams

circuitswiring.com/tag/license-plate-light/

2008 Volkswagen Newbeetle Main Fuse Box Diagram 2008 Volkswagen Newbeetle ...Parts: rear window defogger, shift lock, battery positive voltage, interior light, A/C clutch, ... brake light, daytime driving light, wiper and washer system, vacan, fuel pump, central ... 1997 Suzuki Geo Tracker Left Dash Fuse Box Diagram.

#? license plate light - Circuit Wiring Diagrams - Page 3

circuitswiring.com/tag/license-plate-light/page/3/

Audi A4 Engine Fuse Box Diagram Audi A4 Engine Fuse Box Map Fuse Panel ... mirror control, wiper, washer, horn, brake light, cruise control, heated rear window, ... 2003Suzuki Aerio Dash Fuse Box Diagram 2003 Suzuki Aerio Dash Fuse Box ... rear defroster, fuel injection controller, radio, A/T controller, hazard light, ...

the FSM show this.
and maybe , alldata.com

what makes you thing your cars harness is right for this.
jeep.com see parts list. and look for free.
http://www.factorychryslerparts.com/

check to see if the wire connector is plugged in properly

Not so simple procedure, try and follow all your steps and replace all screws...Not familiar much with the Liberties but, usually access to the wiper will be somewhere in the back of the hatch. You can pretty much figure it out from there.

REMOVAL

1. Disconnect and isolate the battery negative cable.
2. Remove the rear wiper arm from the rear wiper motor output shaft.
3. Using a small thin-bladed tool, gently pry at the notch in the base of the rear wiper motor output shaft bezel to unsnap the nut cover from the bezel .Be certain to take proper precautions to protect the outer tailgate panel and its paint finish from damage during this procedure.
4. Remove the nut that secures the rear wiper motor output shaft to the outer swing gate panel
5. Remove the bezel and gasket from the rear wiper motor output shaft.
6. Remove the trim panel from the tailgate inner panel.
7. Disconnect the tailgate wire harness connector for the flip-up glass ajar switch from the flip-up glass latch connector receptacle.
8. Disconnect the tailgate wire harness connector for the rear wiper motor from the motor connector receptacle
9. Loosen the two screws that secure the rear wiper motor mounting bracket to the top of the tailgate inner panel.
10. Slide the rear wiper motor and mounting bracket forward far enough to disengage the two mounting screws from the keyed slots in the top of the tailgate inner panel.
11. Remove the rear wiper motor and mounting bracket from the tailgate as a unit.

To Install just reverse steps

I would check if they also run off of a relay, You could have a wire that is either broke or it is grounding out somewhere.

Lets deal with the fan. Only two things can cause a fuse to pop. A short in the wiper motor. Unplug the connector on it. It the fuse does not blow now you need a wiper moter. If it still blows the positve wire going to the motor is touching medal somewhere. You will need to inspect the wire going from the fuse block to the wiper motor. . Also sounds like you have no power to the brake switch.. Another fuse issue or a broken wire somwhere before where you bypassed the switch

Did the new lens come with new sockets? If not damage may have occured there that you cant see. only other possibilty is wiring damage in the rear that may be hard to see. The condition you describe is simple "backfeeding" if you look hard enough youll either find bad sockets or damaged wires close to the lens that took the hit. Hope this helped. Thanks

look for rear wiper fuse and relay.because both circuits is tie together . look in glove compartment for the manual .it will show where all fuses and relays located.

If there is a separate switch for the rear wiper there might be a separate fuse. Check to see if your rear window cleaner works. If it doesn't check your fuse. If it does work i suggest that you replace the switch or check the connections of the switch. I hope this helps.