The speedometer stopped working, the traction control keeps kicking in, the stability control stopped working(cannot hear the air compressor), and the ABS light is intermittent and can feel it when braking
Check the body control module under the dash
SOURCE: stability control engaged and my traction contol comes on
all wheel drive and stability control are a lot alike, in fact you are better off with all wheel drive.
These vehicles have all four wheel speed sensors and the braking system keeps the speed of all four as close to the same as possible to control slippage.
Power is decreased to any wheel that is moving faster than the others so optimum traction is obtained. and this may cause this problem.
SOURCE: 2002 yukon denali abs problem
does the abs light come on ? there was one cause on the van that i owned (ford windstar) that can happen to any vehicle. the ring that the sensor reads from can become crack. that causes the teeth to not be aligned properly. just curious... have you had your brakes replaced recently ?
SOURCE: service ride and service stability what does that mean?
this means that you have a fault with your stability control system. the stability control is designed to prevent a rollover it detects body roll when you are driving the ride control is the air suspension sytem this keeps ride hieght the same based on how wieght is in the vehicle. check the links that connect the switches to the suspension you may have one dissconnected (these links wear out over time you night have to replace them) there is one on each wheel postion if you need anything else let me know
SOURCE: 2003 GMC YXL DENALI - "Service Ride Control" Error message
check youer air shocks for leakes and rear hight sensor
SOURCE: 03 Yukon Denali Traction Control/ ABS Problems
my 2000 yukon has the traction control light on and the abs light on any anwsers?
782 views
Usually answered in minutes!
×