At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Most times when I start my 2,0 petrol passat the oil light flashes 5 times and "workshop maintenance" flashes on the screen. changed oil since and checked levels. Any Ideas?
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Hi. I am not sure of the exact workshop flat rate time, but the subframe needs to be lowered. I think 3 hrs is a fair time to do this repair. A wheel alignment would be needed as extra.
car needs oil pressure or bearings will wear out in short time. Do not drive or start engine with this light on. Might only be pressure sending unit. Can replace sending unit and start briefly to see if problem resolves. If light still stays on, shut off engine and have oil pump replaced.
CHECK ENGINE OIL LEVEL SOUND LIKE LOW OIL LEVEL.CHANGE OIL IF IT HAS BEEN OVER 3000 MILES OR OIL LOOKS DIRTY CHANGE IT.IF OIL CHANGE DONT HELP HAVE OIL PRESSURE CHECK TO SEE IF OIL PUMP GOING BAD OR YOU HAVE A FAULTY OIL PRESSURE GAUGE.
"Check engine light" EMISSIONS WORKSHOP! Do you want to shut it off???
After reading all of the negative comments and how much money Passat owners have spent due to this manufacturer's problem, I am going to save the day and save you $$$ by showing you how to "reset" the diagnostic computer which makes the "emissions workshop-check engine light come on! (This is the same thing the VW dealer will charge you hundreds of dollars to do.) To turn off the "Check Engine" (Emissions Workshop) light, simply follow these 5 basic steps:
1. Pop open the hood.
2. Insert the key in the ignition and turn without starting the engine until all of the dash indicators light and warning tones sound.
3. With the key still in the ignition, use a 10mm wrench or socket to loosen and completely disconnect the negative (-) battery cable from the battery. Wait about 60 seconds before reconnecting.
4. Re-connect and tighten the negative (-) cable to the battery and close the hood.
5. Start the engine. THE "CHECK ENGINE" LIGHT HAS GONE OUT!
If the light stays on, then there really is a problem. If it has turned off, be glad, but don't be surprised to see it come on again in a few weeks. If it comes on again, simply follow steps 1-5. Remember... This quick repair is for those who just can't stand looking at this light or afford to visit VW every time this light comes on. If you feel the need to service the vehicle, service the vehicle. I hope this has made your "NIGHTMARE" a little easier!!!
maintenance light flashes 10 times on start up
×