SOURCE: 04 Dodge SRT 4 crankshaft sensor
The Crankshaft Position Sensor is located directly next to the starter.
Reverse Order to install except note that:
Use a twisting motion when installing the sensor.
Install and tighten the crankshaft position sensor bolt and tighten to 9 N·m (80 ±15 in. lbs.).
SOURCE: Can't find where the crankshaft position sensor is
It is located around the crank pulley. It will have 2 to 3 wires going to it. That will be the only wires that will be located around the crank pulley.
SOURCE: Camshaft sensor location
The cam sensor on the 4.7 is located toward the forward edge of the right cylinder head (passenger side). This has a 3 wire connector, tan/with yellow tracer is sensor signal, black / light blue tracer wire is sensor ground and the orange is the 5V supply.
SOURCE: 2002 dodge stratus crankshaft sensor location?
The crankshaft or the shankcraft as we refer to it is inside the engine, it turns over the pistons. Never heard of such an animal. You may have a fuel pump going out, clogged fuel filter, fuel injectors, Idle air control valve going out, bad plugs, plug wires or distributors. Just began checking them one at a time.
SOURCE: were is the crankshaft position sensor located on
ANSWER: CRANKSHAFT POSITION SENSOR - 4.7L V-8 ENGINE
REMOVAL
The Crankshaft Position (CKP) sensor is located at the right-rear side of the engine cylinder block CKP Sensor Location/Removal/Installation - 4.7L V - 8 Engine the cranks sensor is positioned and bolted into a machined hole in the engine block
Disconnect CKP electrical connector at sensor.
Remove CKP mounting bolt CKP Sensor Location/Removal/Installation - 4.7L V - 8 Engine
Carefully pry sensor from cylinder block in a rocking action with two small screwdrivers.
Remove sensor from vehicle.
Check condition of sensor o-ring.
INSTALLATION
Clean out machined hole in engine block.
Apply a small amount of engine oil to sensor o-ring.
Install sensor into engine block with a slight rocking action. Do not twist sensor into position as damage to o-ring may result
CAUTION: Before tightening sensor mounting bolt, be sure sensor is completely flush to cylinder block. If sensor is not flush, damage to sensor mounting tang may result.
Install mounting bolt and tighten to 28 N·m (21 ft. lbs.) torque.
Connect electrical connector to sensor.
Fig. Fig. 3: Crankshaft position sensor location-V6 and V8 engines
157 views
Usually answered in minutes!
×