Oil was changed in January 2013 and has not been driven. oil dipstick shows full. light continues to come on daily.
SOURCE: Maintenance needed comes up on the display for
i found this on a Murano forum, so i cannot validate whether or not it works.
-To reset the maintenance notice on the display, turn the ignition key to ON, with engine off. Select the "Maintenance Schedule" key by using the button to right or left. Using the button select the "Reset" key and push the "Enter" button.-
Hope this helps,
matt
SOURCE: hello!wen i bought my murano 2005 model,was
I have an 06 with the display, you should have a button with MAINT to the far right side of the control center.
Turn the key on ACC,press MAINT button on right end, press down on the "enter" button then press "enter", you may need to move the :"enter" button up but usually it will be on the reset, (Reset) will be lit yellow when ready for you to press the "enter" button to reset it. You should see the Driving Distance bar dissappear/reset to the starting point.
Works for oil changes & tire rotation. You can set the specific distance with the same control, moving it left to right when it is in the "change" position.
good luck
If the oil level goes up, something has to be leaking into the engine oil pan.
That would either be gasoline from the injectors or coolant from the radiator. If you are not adding coolant, it could be a leaking injector.
215 views
Usually answered in minutes!
×