SOURCE: light bulb change
In here you can find the solution: Exterior bulb removal
This is the guide image 1 and guide image 2
Another info: Jeep-WJ-2002-Cherokee-Service-Manual-PDF-08L-Luces (page 8L-10 and next)
In spanish language, but with the pics, you can understand it
Good luck.
SOURCE: Head Bolt Torque for a 2000 Grand Cherokee Laredo 4.0L
the torque is a 4 step process
1 torque all bolts to 22 ft/lbs
2 torque all bolts to 45 ft/lbs
3 recheck all bolts to 45 ft/lbs
4 torque bolts 1 thru 10 to 110 ft/lbs
bolt 11 to 100 ft/lbs
bolts 12 thru 14 to 110 ft/lbs
bolt #1 is the fourth bolt from the front on the passenger side....#2 is the fourth bolt on the drivers side then you continue in a clockwise order
SOURCE: pressure of the engine(oil sign)grand cheroke 2000
When the engine is cold, the oil pressure will be higher. It drops as the engine warms up and heats up the oil. If the pressure gauge gives readings that seem to be wrong, it's possible that the oil pressure sending unit is defective, and should be replaced. If the difference you are seeing in the gauge is due to variation in engine and outside temperatures, the it's normal, and don't be concerned.
SOURCE: Where is the washer pump in a Grand Cherokee Laredo 2000
It is located in the bottom of washer reservoir (bottle).
SOURCE: service 4 wheel drive censor is being triggerd
if you are leaking gear oil from the rear case you most likely need a new gasket or rust has set in and there is a hole or even pin hole present but most likely gasket the censor is working telling you there is an issue that needs addressing so fix that with a drain pan under it the { pumpkin as it is often referred to adn a series of bolts remove them remove the cover slowly to allow any excess oil to drain into the pan and remove it inspect it and replace if needed then scrape clean the old gasket and replace it as well if new cover is needed or if not remove old gasket from that as well and re-adhere new gasket and reinstall remove square bolt with an extension and a socket wrench and fill with new oil to the point if it just begins to run out of the filler hole replace bolt and tighten it this will cure that issue .let me know if the issue persists and we can move onto the next step if needed ...
65 views
Usually answered in minutes!
×