Cars & Trucks Logo

Related Topics:

Robin Bowman
Robin Bowman Posted on Feb 22, 2013
Be the first to answer

Where is the logic module located in a 1995 dodge ram 1500 318motor

It isnt getting fire

Answer This Question

5 Related Answers

Anonymous

  • 5 Answers
  • Posted on Jun 02, 2009

SOURCE: Reverse light switch on 1995 Dodge Ram 1500

switch is just above trans pan and below shift linkage requires a thin (crome 1" socket) to remove

Ad

Anonymous

  • 8 Answers
  • Posted on Jun 18, 2009

SOURCE: I have a 1998 dodge ram. Does the transmission

No ..there is no vacuum modulator on any dodge transmission...they never ever had them

badealer888

Stan Cather

  • 414 Answers
  • Posted on Jun 27, 2009

SOURCE: cannot locate ignition control module 1985 ram

try right at bottom of distributor. just below cap.

Anonymous

  • 467 Answers
  • Posted on Jul 30, 2009

SOURCE: my 1995 dodge intrepid won't start. It is getting

check the map sensor and the fuel pressure at the engine

Anonymous

  • 986 Answers
  • Posted on Oct 03, 2009

SOURCE: firing order for 1995 dodge ram v6 magnum diagram

1.6.5.4.3.2

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

Need to know where the heater module is located in my 1995 Dodge Ram 2500
its called a heater core. The hot engine water goes into the passenger compartment through the engine fire wall.
then it goes through the heater core and radiates out heat and the water returns into the engine.
They are hard to get to !
this you tube video shows how difficult it is to get to the heater core.
https://youtu.be/3gs0NhxUnFA
Read full answer
Nov 24, 2021 • 1995 Dodge Ram 2500
1helpful
1answer

Where is the body control module located on a 2009 dodge ram 1500
Driver side,top corner towards the fire wall
Read full answer
Oct 23, 2014 • 2009 Dodge Ram 1500
0helpful
1answer

Location of security key ignition module/2000 jeep cherokee limited
a jeep dodge, ? nice, franken jeep.
i bite on jeep
its in the book , RTM , read the manual.
http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

Read full answer
May 28, 2014 • 1995 Dodge Ram 2500
10helpful
3answers

Diagram firing order 5.9 dodge
Not sure if you still need this but here it is!!!



c17hydro_136.gif

5.2L and 5.9L V8 Engine Firing Order: 1-8-4-3-6-5-7-2.Distributor Rotation: Clockwise

Read full answer
Aug 18, 2010 • 1995 Dodge Ram 2500
0helpful
4answers

I have a '85 Dodge ramcharger 2wd with a 318 in it that won't start up. I have changed the coil,which has power coming into it but no spark coming out, the entire distributor assembly, the starter relay,...
I Would Say : Crank Sensor is Bad !
Read full answer
Aug 10, 2010 • 1985 Dodge Ramcharger
0helpful
1answer

Looking for fuel filter on 95 dodge ram magnum van 5.2 liter engine
The filter is located in the fuel pump module, on top of the fuel tank
Read full answer
Feb 07, 2010 • 1995 Dodge Ram
0helpful
1answer

1995 dodge ram v8 it has a kill switch i have to push in while starting the truck, the truck trys to start its like it is not getting gas to the engine. if i get the truck started it runs fine once the...
can not find gas kill switch for 1996 dodge ram 1500
Read full answer
Jan 27, 2010 • 1995 Dodge Ram
2helpful
1answer

1995 Ram 1500. Just died? No votage to coil, no spark?
The power supplied to the fuel pump, ignition coil, fuel injectors and parts of the power module is controlled by the logic module through the Automatic Shutdown Relay (ASD):
The ASD relay is closed (allowing power to flow through it) when the ignition is first turned on. If the signal from the ignition reference is lost while the engine is running, the logic module cuts power to the ASD, which in turn removes power from the fuel pump,ignition coil, injectors and those parts of the power module.  This causes the engine to shut down.
Failure of the automatic shutdown relay is often shown as inexplicable stalling or refusal to start. The ASD can be triggered by a broken wire or short in another place, e.g. the fuel pump.  Hope this helps, and did you try to retrieve any DTC codes?? Be glad to help friend.
Read full answer
Jul 01, 2009 • 1995 Dodge Ram
0helpful
1answer

No fire, Won't Start
immobilizer , crank and cam position sensors have not being mentioned
dodge code 32 refers to faulty EGR and not to ignition problems
also if the ignition switch is faulty there will be no run circuit to provide power for the ignition in the run position
Read full answer
Nov 14, 2017 • 1995 Dodge Ram
0helpful
1answer

Cannot find the code connector 1995 Ram 1500
The data link connector is a dedicated diagnostic scan tool connector. It is located in the engine compartment against the fire wall. It links the engine controller to the Diagnostic Readout Box (DRBII) scan tool or the Mopar Diagnostic System (MDS), or any other Chrysler-compatible diagnostic scan tool.
Read full answer
Apr 03, 2009 • 1995 Dodge Ram
Not finding what you are looking for?

View Most Popular

1995 Ram

  • Cars & Trucks

Related Question

Need to know where the heater module is located in my 1995 Dodge Ram 2500

  • 1995 Dodge Ram 2500

324 views

Ask a Question

Usually answered in minutes!

Popular Questions

1996 Dodge Ram Transmission shifting problem

1996 Dodge Ram

Losing Oil Pressure in Dodge Ram

1999 Dodge Ram

1999 dodge ram 1500 5.9 firing order diagram

1999 Dodge Ram

I need a diagram for rear drum brake assembly

1999 Dodge Ram

No heat in a 99 dodge ram

1999 Dodge Ram

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...