The turn signals and brake lights use the same circuit and filament in the bulbs. The tail lights are on the other circuit which comes from the headlight switch.
Do you have power on the tail light fuse ?
Brake lights and turn signal both work off the same wire one for left and one for right but the tail light both sides work off one wire check the wiring harness and check the ground it will be in the frame on the rear drivers side.
SOURCE: Non-working tail lights
Tail light bulbs used are double element one is tail one is turn check your bulbs and, make sure the lamps for your turnsignal have two pins and, are a different number than your other lamps
SOURCE: 1979 Ford Bronco 400M engine. Tail lights work but
The brake light and the turn signal are the same bulb. Most of the time if the bulb on the dash stays on it is because a bulb is blown and thats the way it tells you.
SOURCE: Brake lights not working at tail lights but the
the upper brake light works differently than the outer lights. check your brake light switch by the brake pedal.It will have a plunger switch on it. The center brake lamp works off a power convertor instead off the brake light switch. The switch has a separate wire for that which is still working
SOURCE: 1992 ford ranger =no tail lights,,,,brake and turn signals work
try turning your lights on.....
1,906 views
Usually answered in minutes!
×