What is the code for Chevy Blazer c0221 what do this code mean

SOURCE: service 4w drive lightcomes on& off 2001 blazer

Right Side window motor don't work

SOURCE: que motor tiene la chevy blazer 4w. 99 y que

LET ME TRANSLATE

SOURCE: My 1999 chevy blazer won't

the two plugs might be the ones connecting the wireing to the back of the 4WD pushbuttons panel.located to the right side of steering wheel on the dash. pry it out gently with a slim screwdriver.

SOURCE: i have a 2000 blazer

Hi,

You will want to check for any trouble codes in the TCM, (tranfer case control module) to see where the problem might be.

Obtaining Diagnostic Trouble Codes
The transfer case shift module is equipped with the ability to store diagnostic information, which is useful to a technician in the event of module., component or wiring failures. This information can be retrieved from the transfer case shift control module by way of flash codes, which are displayed on the three transfer case shift control switch buttons. These buttons are located on the instrument panel to the right of the steering wheel Before obtaining DTC's perform the following transfer case control module (TCCM) Self-Test.

TCCM Self-Test

1. Observe the transfer case shift control switch indicators while turning the ignition switch to RUN. A properly operating system will flash all indicators and then will return to the current gear. If the system is operating normally, then proceed to Displaying Codes.

1. If the TCCM failed the Self-Test, then test the following circuits.

• • Battery Positive Voltage (40 and 1640), and Ignition 3 Voltage for battery voltage

• • Ground Circuit for ground

• • Diagnostic enable circuit for an open or high resistance

• • If the above circuits are normal but the TCCM still fails the Self-Test, replace the TCCM.

DTC Displaying

1. Turn OFF the ignition for 10 seconds.
2. Connect pin 13 on the data link cable to a ground. The data link connector is located in the cab under the instrument panel on the drivers side.
3. Turn ON the ignition, with the engine OFF.
4. Observe the transfer case shift control switch select buttons for flashing codes. Refer to Perform a Diagnostic On the TCCM.

Important: If the transfer case shift control switch buttons all blink only once and then stop, no fault codes are stored in the transfer case shift control module.

• When one DTC is stored in memory, that code will blink that number of times followed by a 3 second pause and then repeat.

• If more than one code is stored, the first code will blink, followed by a 3 second pause and then the second code will blink.

• This sequence will continue until PIN 13 on the DLC is no longer grounded.

If the TCCM will no communicate the presence or absence of DTC's, test the above circuits in Self-Test Step 2. If the circuits are complete, then replace the TCCM.








Let me know,if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!