I have changed the iac motor and looked for vacume leaks ,no leaks also cleaned the plate and it still wont idle lower than 1.200 rpm help
SOURCE: 2001 v6 escape rough idle when cold
To update my earlier repair on the 2001 6 cyl Escape: When cold, and when the ignition was turned over but no accelerator pressure given, the rough idle finally returned the P0303 code again when the check engine light came on indicating that it wasn't caused by the plugs or the coil. FYI, I had replaced the intake manifold gaskets during the original repair and just prior to that I had replaced the fuel filter which was very dirty (I cut it open to see).
The repair manual referred to fuel injectors as a possible problem. I have run three tanks of fuel using different injector cleaning products and am very pleased with the results. Cold starts are much smoother and I am unable to coax out the P0303 code or any other code.
My opinion, change the fuel filter, use a fuel injector cleaner for a couple of tanks, change the plugs if the problem still exists. The coils were not the problem on my vehicle.
SOURCE: codes 171 and 174 2001 ford winstar
dont take soo much in consideration after you have make all this things, some time is on only for any wire faulty, or a shrt electrical arc in any place in wire system. ask auto tap mechsnics for this maybe they have similar case before.
SOURCE: Code P0506, Idle control system RPM low
It's common that you get a lot of carbon build up at the base of the throttle body. Give it a good spray cleaning with injector cleaner and dry it with a hair dryer. If you find it still to dirty, you can try it again with a second can or if you can try using Sea Foam that you can buy at an auto parts store like Auto Zone. The Sea foam will clean out the carbon but also create a lot of smoke.
When i say lot's of smoke, just do a search on You Tube for Sea Foam. Good luck and hope this helps.
SOURCE: 2001 FORD F250 5.4L HIGH IDLE PROBLEMS.CHANGED IAC
Does it still idle high with IAC unplugged? Look for vacuum leak at PCV valve, brake booster, egr valve, intake gasket etc.
SOURCE: 1996 f250 7.3 powerstroke has rough idle on starts
it sounds like to that it is either worn/ old injectors,dirtly HPOP (high pressure oil pump) oil worn HPOP pump or dirty fuel filters or fuel. you can take truck to a qualified diesel shop and they can do a buzz test on your injectors and see if they need to be replaced with a buzz test the tester will buzz all eight injectors with engine off and you can hear the buzz of the injectors then it will go through and buzz each injectors individually in firing order to der determin witch ones are bad. the bad injectors will be alot quieter than the other and most testing equipent will show what they are running at. hope this helps.
108 views
Usually answered in minutes!
×