Need a diagram of the lines leaving the Electronic Hydraulic Control Module and going to the front connections of the truck.
SOURCE: chevy s10 broken vacuum line
The plastic line in the wiring harness goes to the heater controls; and believe it or not , the other end goes to the vacuum tank - but its in the FENDER !!!!! behind the ABS, kinda under the drivers side hood hinge - great place to put one ain't it ? No wonder GM is going broke !! Good Luck
SOURCE: 00 Chevy Silverado... ABS EBCM diagram help??? Brake line hookups
Hello,
I hope this helps.
Thank You,
Roy
SOURCE: chevy avalance brake line diagram
Left front weel wobling mechanics says it needs new roters $600
SOURCE: Broken brake line on 1990
1990 Chevy 4.3 l engine runs rough at idle half the time-- sometimes it's OK, other days it's rough and can smell raw gas, as tho it's running rich... any ideas?
SOURCE: 2003 checy avalanche...need brake line
THis is for a Chevy Silverado truck, since I could not find a diagram from GM. Here is a picture showing which line is which...
Looking from vehicle front to rear, there must be the layout, there are three connections along the top. From left to right, the
connections are Front Left Wheel, Front Right Wheel, and the Connector
near Left Rear Wheel that serves both rear wheels. The bottom two
connections go to the Master Cylinder. The Left Connection goes to the
rear Master Cylinder Connection and the Right Connection goes to the
front Master Cylinder Connection.
Good Luck.
2,090 views
Usually answered in minutes!
×