SOURCE: 2006 Chevy Trailblazer LS, dashboard lights, need
Change Engine Oil Light = wrench with a car next to it
StabiliTrak® Service Light = car skidding in a triangle.
This light will come on if a problem is detected in the StabiliTrak®
system
SOURCE: 2006 Chevrolet Trailblazer: Used car have no
that sounds like a stabilitrack or traction control light. you may need to take the vehicle into a dealer to get it hooked up to a computer to see what the fault is.
SOURCE: warning symbol (triangle with an (!) in the middle
tmps " tire pressure monitor system" you have a low tire or tires fill with air if the light stays on take it to your tire shop they can assist you
SOURCE: A yellow light just came on on my 2008 Impala.
Tire pressure monitoring system. Start by checking your tire pressure and set to what the sticker on the drivers side door frame indicates. If this does not turn the light off you will have to re-learn the sensors to the vehicle. This is done by:
reset the tire pressure monitoring system, to do so, you need to get your key fob, and put your ignition key in the ignition, turn it to the accesories position, and simultaneously press the lock and unlock buttons on the key fob. hold them until the car honks the horn.
then take something to let out air in the tires, you need to start with the left front then go to the right front, then the right rear, then the left rear.
start at the left front, drop the pressure in the tire until the horn beeps, -usually takes 8 seconds or so. then repeat on the other tires in the order above.
After you finish with the final tire, the horn will honk again, then you know your done. usually honks 2 times.
and then you can turn the key off, and set your tire pressures.
SOURCE: triangle with car and skid
{: ) These triangles you saw is for the Stabilitrak (traction control) indicators. Normally these lights should be off after the engine has started, unless you disable it by pressing the stabilitrak button. Sometimes it lights up automatically when driving under certain road conditions, and will turn off later when normal conditions resume. A wrench beside the triangle indicates a fault is detected on thge traction system and it requires servicing.
What you can try, stop the vehicle, turn ignition off for a few seconds to reset the system, and then restart the vehicle. If the lights wont go off, then tghe vehicle really needed to be checked right away.
617 views
Usually answered in minutes!
obviously I have no owners manual or I wouldnt be asking js
×