Where is the electronic throttle control for 2005 dodge durango 5.7 hemi?

SOURCE: Electronic Throttle Control

DTC P2106 Throttle actuator control system-forced limited power DETECTION CONDITION
• The PCM monitors the throttle actuator control current when the ignition switch is on. If the control current is less than 8 A or more than 11 A, the PCM determines that the throttle actuator control system is under forced limited power. Diagnostic support note
• This is a continuous monitor (CCM). • The MIL illuminates if the PCM detects the above malfunction condition in the first drive cycle. • PENDING CODE is available if the PCM detects the above malfunction condition. • FREEZE FRAME DATA is available. • The DTC is stored in the PCM memory. POSSIBLE CAUSE
• Throttle actuator malfunction • Connector or terminal malfunction • Open circuit in wiring harness between throttle body terminal A and PCM terminal 1B • Short to power supply in wiring harness between throttle body terminal A and PCM terminal 1B • Short to GND in wiring harness between throttle body terminal A and PCM terminal 1B • Open circuit in wiring harness between throttle body terminal B and PCM terminal 1C • Short to power supply in wiring harness between throttle body terminal B and PCM terminal 1C • Short to GND in wiring harness between throttle body terminal B and PCM terminal 1C • PCM malfunction
and for the other one

the dealers need to reflash the powertrain module ( ETC ) ...

hope i'll not get that problem on my 04 hemi...

SOURCE: Electronic Throttle Control light

I took my 2004 Dodge Ram 1500 5.7L Hemi to a mechanic that works from a garage at his home, recommended by a friend of mine. He removed and cleaned the throttle body and sensor(s?), then reinstalled them, and then disconnected both battery cables and held them together for 2 minutes so that the engine controller could reboot with the factory default settings, then reconnected them. I had bought a can of throttle body cleaner on my way over to his house for about $3.00. He charged me $40.00 for the job. This was done mid-February, about 10 weeks and 2500 miles ago. So far, the problem Has Not happened again, the truck has been running great!

SOURCE: Electronic Throttle Control

I had same problem on mine. The wire harness under the throttle body cover rubbed and was cut in two. If you remove the cover and unplug the etc you can feed the harness under the plug wires to inspect them.very common problem on this vehicle.

SOURCE: Where is the throttle position sensor at on a 2005

THIS ENGINE HAS ELECTRONIC THROTTLE CONTROL..THERE ARE 2 THROTTLE POSITION SENSORS LOCATED IN THE THROTTLE BODY,COMPLETE ASSEMBLY MUST BE REPLACED IF DEFECTIVE..IT ALSO HAS SENSORS IN THROTTLE PEDAL ASSEMBLY AS WELL..WHAT TROUBLE ARE YOU HAVING?

SOURCE: where is the crankshaft position sensor on a 2005

Passenger side of the engine just above the oil pan. Look for the wire harness going into the block.