SOURCE: changing fuel pump on a 1989 gmc serria p/u
buy an aftermarket electric pump from Summit Racing and mount it on the frame rail right near the filter....do not waste time dropping gastanks and paying for ridiculous gm type in the tank pumps, the in the tank pump is a giant fock u to the public from the automakers.....remember the little mechanical cam driven two bolt cuteys? 15 bucks and 15 minutes and you were done.... thanks big three!
SOURCE: 2007 gmc sierra 2500 IAT sensor
Well, the IAT (Intake Air Temperature) sensor is located on the air intake duct between the filter and the throttle body (Assuming you have the 6L motor). The wires are easily visible at the plug that connects the sensor to the wiring harness. That's the easiest place to access them.
SOURCE: oxygen sensor
Hello gobabygo1, my name is JShreader. Thank you for choosing fixya.com.
There is 4 Oxygen Sensors on this model Truck. I uploaded a picture showing you exactly where each of the 4 Oxygen Sensors are located. It is in .pdf format. You can download it by clicking HERE. I hope this helps you. If you have any more questions or need any more diagrams, please don't hesitate to ask...Thanks again, JShreader!
SOURCE: where do i find a knock sensor a 1993 gmc sierra
Should be on the right side of the engine by the starter.Has a 1 wire connector.It does not go into the cooling system so you can just take it out without draining the coolant.Hope this helps.Good luck.
SOURCE: where is the cam sensor on a 2001 gmc 3500 serria 8.1
Installation ProcedureImportant: Inspect the CMP sensor O-ring for wear or damage. If a problem is found, replace the O-ring. Lubricate the new O-ring with engine oil before installing.
Important: The CMP sensor bolt has self-tapping threads, care must be taken, NOT to strip the threads when installing.
Tighten the bolt to 12Nā¢m(106 lb in).
482 views
Usually answered in minutes!
×