Ive got a proton jumbuck the hazard lights and the indicators are not working. Ive checked the fuses and none are blown. I tested the flasher in another vehicle and its working fine. I doubt its the switch as both the hazard light AND the indicators are not working. Any theories? Does anyone have a wiring diagram? Thanks in advance
May be you should make a diagnostic and you can do it in a garage or you can do it by yourself if you want to do it by yourself you need some tools and you can find some good ones here: diyobd2.fr
SOURCE: proton jumbuck electrical fault on
I had a similar problem with my jumbuck,2 sets of keys only one worked. Replaced battery now ok.CR2032 ,tednanango
SOURCE: hi hope you can help i have a proton jumbuck and
it is possible that you have a blown fuse, HIGH & LOW beams are usually on different fuses, most likely for safety reasons so as if either one blows at least you still have lights, check the fuses in the fuse box......hope this helps......cheers.
SOURCE: no hazard lights
Check the hazard switch and the connector to hazard switch see if u have the power and earth to hazard switch if there is power and earth to switch then replace ur hazard switch its faulty but if there is no power and earth to switch then it has whirring problem
1,793 views
Usually answered in minutes!
×