1995 Toyota Camry DX: I have electronic door locks. The driver door lock is jammed and the door cannot be opened. The actuator for the lock on the door handle on the inside of the car is jammed and cannot be pused back to unlock the door. The other 3 electronic door locks are working.
1. How can I correct the problem?
2. Can I disconnect the electronic door lock system or for just this one door and use my key to unlock and and lock the driver's door?
Send solutions to [email protected]
Thank you.
Bryan
SOURCE: 1998 Toyota Camry Inside Door Handle
The Door Panel Has Got To Be Removed.
Start By Removing The Handle Cover You Mentioned On The Handle Careful Not To Break It . A Small Screwdriver Can Help.
Next Remove Black Piece By The Window By Pulling It Strait Outward. Then Remove The Screw Cover On The Actual Handle You Use To Close The Door. Remove The Screw From Below It And There Is One Under The Front Edge Of It As Well. There is 2 screw along the bottom edge of the door as well. then remove screw up by the mirror. now remove this little plastic clip right on the side closest to the outer edge by pressing the center and pulling the whole thing out. Then There Are 2 10mm screw that hold on the door latch remove and slide the whole handle forward and it should come free. Now Reverse all these steps with the new handle in place.
THIS SEEMS HARDER THEN IT IS I PROMISE.
If You Have Any Questions What So Ever Please Feel Free To Post Then And I Hope I Helped At least A Little.
SOURCE: 1991 Toyota Camry DX - Front Passenger Door Lock won't disengage
Your power door locke solenoid is seized. You will need to replace it. You are going to have to get the entire door panel off, and then reach in to manually pull the solenoid arm to retract the lock mechanism. Then the door will open.
SOURCE: 2005 Toyota Sienna Sliding Door Won't Open
Have 2005 Sienna and its Driver side door was not openning. Cheap dealer fixed it himself in front of me. After opening the doors plastic assembly while sitting inside with a screw driver. Then he bent the clip towards left where the metal wire is connected. If you guys want to see what he did i would record a video and upload for you guys. Let me know at [email protected]
SOURCE: 1995 Toyota Camry tail light. no screws to
Yes, You need to remove the complete plastic lens, but its only one screw and after gently pull the light to the side to remove it. After You can change the bulbs as You wish. In the owner instruction manual its detailed described. If You have email, I can send You the photos.
189 views
Usually answered in minutes!
×