How to Program a Key FOB for the Chevy ... your Chevy, if you obtain new or replacement keys they will need programming to work with ... How Do I Program MyKey Fob? ...How to Program a Key FOB for the Chevy ' eHow.com
www.ehow.com/how_7508133_program-key-fob-chevy.html
SOURCE: key fob not working after battery change ford focus 2006
Try reprogramming it.
1. Turn the ignition from OFF to RUN 4 times within 6 seconds.
2. Turn the ignition OFF. The system will chime to confirm programming mode.
3. Within 20 seconds, press any button on first keyless remote.
The system will chime once to confirm programming.
4. Within 20 seconds, press any button on second keyless remote.
System will chime once to confirm programming.
5. Turn ignition to RUN to exit programming mode.
SOURCE: How do I program my key for my 2006 Chevy Impala?
Add Duplicate Key (PK3 or PK3+ key)
1. Insert an existing key into the ignition cylinder.
2. Turn the ignition cylinder to ON (RUN) and back to OFF.
3. Remove the existing key and, within fifteen seconds, insert the new key
and turn it to ON (RUN).
4. The security light will light up for two seconds to indicate success in programming
the key into the vehicle.
Originate New Master Key (PK3 or PK3+ key)
1. Insert new key into ignition cylinder and turn it to the ON (RUN) position.
The security light on the dash will illuminate and stay on for ten minutes.
2. When the security light goes out, you have one minute to start the next
step. Turn the ignition cylinder to OFF and then back to the ON (RUN)
position. The security light on the dash will illuminate and stay on for ten
more minutes.
3. When the security light goes out, you have one minute to start the next
step. Turn the ignition cylinder to OFF and then back on the ON (RUN)
position. The security light on the dash will illuminate and stay on for ten
more minutes.
4. After the security light has gone off the third time, the key has been programmed
into the vehicle’s computer and will operate the car. It has replaced ALL the
previous electronic key codes and is the ONLY key programmed into the
vehicle’s computer.
Add Duplicate Key (PK3 or PK3+ key)
1. Insert an existing key into the ignition cylinder.
2. Turn the ignition cylinder to ON (RUN) and back to OFF.
3. Remove the existing key and, within fifteen seconds, insert the new key
and turn it to ON (RUN).
4. The security light will light up for two seconds to indicate success in programming
the key into the vehicle.
SOURCE: 2008 chevy malibu. how to program keyless entry remote
You must take it to the Chevy dealer.
Testimonial: "thank you"
SOURCE: How to program a new hyundai sonata key fob
First find little notch on side of FOB that will allow you to open the FOB itself. Next insert mini flathead and twist hard until unti snaps open. Hopefully you didnt break it yet. Then pull out circuitboard within FOB. nEXT remove battery and press red button and hold for 5 seconds. Replace Battery then put circuitry back in place. Now, with circuitry in place hold all three buttons while simultaneously pressing the red circuit overload reset button on the board. Then, press the thre buttons in this exact order ( this is a very important step) press the door unlock buttton twice before waiting three seconds then pressing the hood open button 3 times followed by a 5 second delay then pressing lock> But wait, before you press lock you must "chime" this code to the song "waiting for a girl like you" by foreigner. The code will then automatically find your cars code, get married and then you will be in luck - many baby remotes will start to fall from your dash board. If this doesnt work it is probably due to the fact that you have more of a hard rocker or redneck remote and follow all prior procedures but replacethe song with only "welcome to the jungle" or tears in my beer". If this still doesnt work, grab a beer and share it generously with your remote. When this doesnt work, (as I suspect at this point it wont) take your remote and after finishing the 12 pak, take the remote to your local hyundai dealer and threaten to throw up in the main sales room if they dont program it for you. Mae sure you slur the fact that your dad owns Hyundai (even though you are as white as can be) and that you will sue them all out of work if they dont do this for you ...plus you then proceed to puke on the front door handle and tell the customers " this is what you have to look forward to if you get oneof these BEutieeeesss hahahaha" while rubbing your puke infested hands all overtheir nice shirts and blouses, ....this I promise will work. And you should have a nicely programmed remote the next morning after waking up in the drunk tank and the officer gives you a ride home because the mayor of "yourtown" is your neighbor and your supposed to be at home cooking a barbeque for him that after....HIC...that after...HIC that ...noon.
1,840 views
Usually answered in minutes!
http://theandrewhughes.com/2007/05/how-t...
×