Wanting to know how hard it would be to change trans. filter on1998 Mercury Mystique autotransaxle. 2.0L engine
SOURCE: 1998 mercury mystique will not drive in D but will
that is and straight forward system where you have a linkage from shifter to transmission and if it goes and 2 and not i drive then you may have a selector issue where it is out of adjustment! but for me to tell you i have to know if the car shifts through all the gears? if it does then that is most likely your problem if it doesn't shift properly the you have internal transmission failure and have to take it to the shop! hoper that helps and good luck
SOURCE: How do I remove and replace front wheel bearing on
you need to take the tie rod off , the lower ball joint off , take the strut bolt out and remove the nut and washer off the cv axel then pull the whole hub Assembly off then the new bearing need to be pressed in , then reinstall everything not as hard as it sounds
SOURCE: What is the procedure for removal of the radiator
Ford Contour/Mystique/Cougar 1995-1999 Repair Guide
Radiator -REMOVAL & INSTALLATION
(see Figures 1 through 7)
Fig. 1: Remove the upper radiator hose from the radiator
Fig. 2: Use a back-up wrench to remove the transaxle cooler line connections-automatic transaxle only
Fig. 3: the lower transaxle cooler line connection
Fig. 4: Remove the passenger side radiator mount and ...
Fig. 5: ... and the driver's side radiator mount
Fig. 6: The condenser can be support using mechanic's wire as shown here, or another suitable device
Fig. 7: Carefully lower the radiator out the bottom of the vehicle
Remove the cooler lines while holding the radiator connector with a back-up wrench.
To install:
Hope helps with this (remember rated this help) Good luck.
SOURCE: i need a fuse box diagram for a 1998 mercury
I need a fuse panel diagram for a 98 mercury sable and i dnt have a manual for the car
1,574 views
Usually answered in minutes!
×