SOURCE: 2000 Chevy Silverado need to reset oil change code.
Turn the ignition key to the run position and pump the accelerator 3 times within 5 seconds.
Please leave feedback!
SOURCE: 2000 silverado z71 service 4 wheel drive light on/off
The problem is with the front actuator.Its flashing in the dash lights because is not functioning properly.Replace actuator and fix problem.Its a 4 or 3 wire screw in plug in front axle,,
I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_a3369546f8067589
SOURCE: how to reset the change oil light on a 2003 chevy
Information courtesy of synthetic-direct.ca
Chevrolet Suburban/GMC Yukon XL, 2000-05 Chevrolet GMC Trucks Silverado, Sierra, 1999-05 Chevrolet Venture 2000
Turn the ignition key to the RUN position. Fully push and release the accelerator pedal 3 times within 5 seconds. If the CHANGE OIL SOON light flashes 2 times, the system is reset. However if the light comes on and stays on for 5 seconds, the system did not reset. Repeat the procedure if the system does not reset.
Best of luck.
Greg
SOURCE: 2006 5.3ltr chevy silverado z71 p0455 andp0449
These codes are for the evaporative emission system.The 455 is the vent solenoid.The 455 is a large leak in the evap.system.The vent solenoid I would replace because they go bad and will not work because they are under the vehicle in the rear of the truck.There is a bulletin for these and the vent valve is installed in another spot.The number for the bulletin is 02-06-04-037E.You should also look for a broken or loose hose or pipe that might have came off.Specially if you ran over something.If none found it could just be the vent solenoid stuck in the venting position.Good luck.
313 views
Usually answered in minutes!
×