The radio turns on....it isn't locked but sound is still not coming in through the speakers. it displays a radio station and accepts cd's,but no sound. HELP!!

Hi,

from your description, it sounds like we can eliminate your car speakers as the issue because the sound from your CDs does not have any issues. In this case, please double check that your car antenna hasn't been bent or tampered because this would be one cause of the radio sound not coming through properly. Also, please make sure to check multiple radio stations to ensure that the issue isn't with just one station.

Thank you.

Sounds like either a wiring issue at the output on the radio, or the audio circuits in the radio have failed. Start with trying to secure the output wires to the radio, if all tight then afraid it is internal.

Turn on the radio and increase the volume if you can hear a hiss through the speakers, chance is the aerial/antenna connection is not hooked up correctly. Another way to check is try tuning to an AM station if you get a signal on AM but not FM then it is The antenna. You may have to remove the radio to get at the connection.

have you had any speakers or bass boosters installed in your car that werent in the vehicle before you purchased. Watch for wiring issues or possibly even battery voltage issues.

tip it out and replace the radio ,it would cost more to replace the output transistors than the radio is worth

If Speaker connections are all good and you know it .The channels could be BLOWN usually the result of Hooking a Booster or other speakers to the wrong polarity in the RADIO Check speaker wire`s for connections from radio .POST BACK WITH MORE INFO!

check the wirings of your speakers and then check the settings on your radio.

I’m happy to assist further over the phone at https://www.6ya.com/expert/ramy_d9e7ebea3891f482

Have you check the mute mode, maybe it is in mute mode.

My van radio runs on 2 different fuses- both in the fuse box under the dash. One runs the lights the other the sound. Hope this helps.

I disconnected the amp and ran jumper wires for the proper speakers (two wires per speaker eight total) . Basically I bypassed the amp now all speakers work and sound fine.