Preparing to install Gforce chip
SOURCE: 1998 Jeep Wrangler 2.5 liter motor timing specs?
you could have vacumm problems making it seem like the timing is off, but the other guys are right on the timing!!!! it could be throw-body problems, like crack manifold problems. This year has thhis type of problem sometime. Try spraying WD-40 around the vacuum hoses, & manifold to see if the motor changes rpm????
SOURCE: location/testing of crank sensor 1995 jeep wrangler
Should be on the bellhousing on the drivers side just where you need rubber arms to reach it.Should have no continuity between b&c terminals (check with ohmeter) Harness plug is usually on the drivers side between the master cyl and the back of the engine (unless someone moved it)
SOURCE: jeep wrangelr Crank Position Sensor
wall5552: there were two engines used in 1992 Jeep Wranglers.
A 2.5 liter and a 4.0 liter. HOWEVER>>>> The location for the crank angle sensor is the same for both.
It is located on the bell housing up near the front at about the 10:00 PM position.
The Cam position sensor is located in the Distributor on both engines as well.
376 views
Usually answered in minutes!
×