SOURCE: Door ajar light stays on but all doors are closed.
one of your door switches is out of adjustment or defective. You can test this by pushing in the switches manually.
SOURCE: 98 Dodge Durango no electrical power
When the armed Vehicle Theft Security System (VTSS) senses that the battery has been disconnected and reconnected, it enters its power-up mode. In the power-up mode the alarm system remains armed following a battery failure or disconnect. If the VTSS was armed prior to a battery disconnect or failure, the system will have to be actively or passively disarmed after the battery is reconnected.
The alarm can be disarmed by locking the vehicle and turning the drivers door lock to the lock (arm) position. Wait a few minutes then unlock (disarm) the drivers door and the vehicle should start.
If the VTSS has been disabled in the high-line Central Timer Module (CTM), the VTSS feature must be re-enabled using the Chrysler DRB scan tool. The clicking you heard was probably from the CTM located behind the glove box.
Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.
SOURCE: door ajar light stays on with all the doors firmly shut
SPARY WD40 AFOUND THE SWITCHES FOR EACH , OR REMOVE EACH SWITCH AND UPPLUG IT, IF LITE GOES OUT THAT SWITCH IS BAD,
SOURCE: 2003 ford focus 2.0L door ajar light wont go off
Hey Jared..my name is Keith..and what you have is a bad door sensor..and you will have to see and figure out which one is bad..i had a bad sensor..after awhile the door ajar light would go out..and then when someone opened the passenger door..then the door ajar light would come back on..so i replaced the door sensor on the passenger side and it fixed the problem..i hope this helps
SOURCE: my door ajar light stays on,and the dome light
If the switch is working, you can adjust the door, or some times the switch.
221 views
Usually answered in minutes!
×