Check engine Code - P0130 and P0134

P0340-cam position sensor malfunction (change)
P0130- O2 sensor malfunction 1/1 (change)

code p0130 refers to heated oxygen sensor (HO2S) 1 bank 1---circuit malfunction causes ---heating inoperative---poor connection---wiring--- HOS I would replace the sensor with a genuine unit to match the cpu settings

PLEASE RATE THIS REPLY FOR ACCURACY

P0130 is the o2 sensor circuit bank1 sensor 1. P0134 is o2 sensor circuit no activety bank1 sensor 1.In other words the o2 sensor on the drivers side before the catalytic converter is bad and needs to be replaced.You will need to reset the computer after its replaced.

First simply disconnect and then reconnect the battery. This will reset the sensor, and may be a possible solution.

All those codes and such an easy fix. ALL of these codes point to your upstream 02 sensor. It's the one on the passenger side of the engine coming off the exhaust, very very easy to get to. Soak that puppy with PB Blaster then remove the electrical connector and remove and replace sensor. TRY to stay away from Bosch 02 sensors, have been known and reported problems with these. In my case, I didn't have a choice but to buy the Bosch, but I haven't had any problems with mine.

Hope this helps, look to get a tad more miles per gallon too.

p0130 is an oxygen sensor code.
p0340 is your camshaft position sensor code
p0336 is your crankshaft position sensor code

as far as the p0130 code those usually are what i call neglected sensors that do not get replaced when they should be. this sensor is expensive but worth the money as it will help on fuel mileage.

on to the camshaft position sensor, i would start here with this. replace that sensor and when you are replacing it, inspect the sensor and make sure the electrical wires going into it are in good shape. after replacing those 2 sensors, go to a parts store who can erase your codes to turn the light off and then let us know if it comes back on and then we will go from there on the repair.

P0130 means that the oxygen sensor circuit malfunction
plse look at the following items.
heating inoperative,poor connection,wiring,ecm.

in AKO look under Self Help> My Library > Fix Your Car > then go to Chiltons or ARRC link from there.

most cars have only 2 o2 sensors one is below the exaust manifold and the other one near the catalytic converter

P0130--O2s sensor circuit 1
P0134--O2s circuit insuffient Act sensor 1
P0135--H02s heater performance sensor 1