This is a 1999 australian ford futura with the drivers window has come of its guide, I cannot get the window into the up postion and the electric part to the bottom of door to fix
SOURCE: window wont wind up on ford fiesta
in the door handle you will see some plastic caps
remove these you will then find some phillips screwsremove them the handle will com off
same with the window winder handle
then check for other screws then pull door card off. but gently bottem out & top up
SOURCE: 1999 Jeep Grand Cherokee Laredo Electrical issues.
if door switches are ok, check the courtesy light relay located just under the front passenger side(above the fuse box)
SOURCE: Drivers electric window stuck in down position
actually you have thought of all but the prob. The track has jumped, making the motor not move the window. Sometimes you can gently slide the window up by hand and then the motor will catch the track and finish rolling the window up
SOURCE: how to remove drivers door panel and window winder
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
SOURCE: drivers door window motor and track broke how to
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Pull back the weather seal and you can readjust the window mechanics
61 views
Usually answered in minutes!
×