Is there a "computer flash update" for my 2001 isuzu rodeo ls 3.2l (v-6)

camshaft position Sensor location???

Isuzu SUV Forum https://www.planetisuzoo.com > threads > camshaft-po...
Jun 23, 2009 - It is located on the inside surface of the front of right cyl head. 2000 Rodeo LS (stock). 78 T/A (far ...

SOLVED: Where to locate the camshaft sensor on a isuzu

Fixya https://www.fixya.com > ... > Isuzu > Rodeo
1 answer
It's on the inside of the cylinder head at the rear of the engine. Will be hard to see it because the intake plenum hides it. where to locate the camshaft ...
Doesn't include: LS ‎' Must include: LS

Where is the camshaft position sensor in my 2002 Isuzu ...

JustAnswer https://www.justanswer.com > Car Questions
May 13, 2020 - My son is a mechanic and the Haynes manual says it's under the lower intake. Need to verify. Share this conversation.
1 answer · Top answer: you are welcome

• 
  

  Isuzu Rodeo: WHERE IS AND HOW TO MEASURE THE ...

  https://www.justanswer.com > Car Questions
  Mar 30, 2013 - If you are just testing the sensor, you can check the cam sensor signal at the ECM on pin 11 of connector number 2. It is the same blue wire.
  
  ..

Yes, they are basically the same, except for paint color combination and a few other changes in interior.
Other than that, the drive train and engine are the same.

I'll have to see if I can find a PDF online.

Visit the on-line store, know as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem.
Best Manuals

Planetisuzoo.com • View topic - Transmission Accumulator Piston Cover

forum.planetisuzoo.com/viewtopic.php?t=38884
Apr 2, 2010 - 20 posts - ‎8 authors Have any of you ever changed the Accumulator Piston Cover on the side of yourtransmission? ... 2001 Isuzu Rodeo LS :: 3.2L V6 Auto 4L30E >> clicky for pics << ... I got the kit, and I even scored the removal tool on eBay. 1991 Trooper Transmission Pan ...
26 posts
Mar 20, 2012
2000 Rodeo Transmission Fix
10 posts
Jun 25, 2011
Smoke coming from bottom of Isuzu ...
24 posts
May 21, 2011
TSB information
7 posts
Jul 23, 2007
More results from forum.planetisuzoo.com

isuzu rodeo transmission - YouTube

? 1:37
www.youtube.com/watch?v=CyJZQLwnfPY
Sep 3, 2013 - Uploaded by besiratabay
2001 isuzu rodeo transmission problems 2002 isuzu rodeo transmission 1999 isuzu rodeo transmission .

Need a vacuum line diagram for a 2001 isuzu 3.5 engine.

get under the truck and hit the tank hard with your hand the pump may be stuck a couple good wacks might work

You've probably fixed this by now. I had the same problem and it wouldn't pass the smog check. I thought I'd have to replace the EGR valve but now know that would have not solved the problem.
The solution was to remove the EGR valve, plug the rear hole and use some carb cleaner down the other hole. I'd get two cans. I sprayed a bunch of liquid in the hole but it just filled up. Had my wife come out and rev the engine for a bit. Finally, the liquid got sucked into the port and I sprayed an entire can in while she kept the engine RPM up. Bolted the EGR valve back on, took it to the Smog check place and it passed with flying colors.

Hi:
You need to call your local Isuzu dealer, and have your VIN number handy, as their service department should be able to get your key code from the VIN number

If P1627 is set when there is a problem with the fuel level sending unit, 100% sure on this problem, replace the fuel level sender in the gas tank, about 2.5 hours, very straight forward job

Tune it up and replace the 02 sensor that keeps setting the codes bank 2 sensor 1. Have your oil and filter changed right before you go for a retest to. That will clear up 3 codes P0300, 0155 and 0154. You might have to replace the fuel sending unit to get rid of P0463 but if the gauge works OK I'd leave it alone.