SOURCE: Honda Ridgeline Service Manual
4WD only operates when gear selector is in L and under 18 mph. the rest of the time your 4Wd will activate automatically if the front wheels start to spin,
SOURCE: Door panel removal from 2005 Honda Accord
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
SOURCE: interior door panel removal 04 honda civic
you must carefully pop off the door plastic clips using a screwdriver and prying gently until they pop out , also remove the screws under any small round plastic screw cover inserts and in the plastic door handle area
SOURCE: 2003 honda civic how to remove door panel
Step one Look at the inside door handle. Behind it you should see a little cover, You pop that off and there will be 2 phillips head screws behind it. remove them.
Pop out the door handle, and unplug the power lock plug,
Youll also have to take the door lock rod, by spinning the plastic door handle 90 degrees until u can wiggle it out.
next remove the sail panel( The little triangle shaped piece in the corner of the door on the top, ( may have a tweeter in it) ( it just pops out)
Next take a screwdriver (flat head) and pry off the cover of the door handle, there will be
2 phillips head screw behind it ( remove screws)
Unplug power window connector (big green plug)
Now just start gently pry the door panel off with a screw driver, see if u can peek behind the panel and see where the panel clips are, and pry near those areas
1. Pull the plastic panels under the seat bottom straight forward to remove them.
2. Remove the six bolts (14mm) holding the seat and center seatbelt in place.
3. Pop the two small plastic covers at the top and behind the seat using a trim removal tool or screwdriver tip covered in masking tape.
4. Lift the seat straight upward.
5. Remove.
The Service Manual states a 35 ft lb torque and must be re-installed in a certain sequence for the 6 seat anchor bolts (not the seat belt bolts). When putting the rear seat back in install the bolts in this order. (1) center left (2) center right (3) left lower (4) right lower (5) left upper (6) right upper.
620 views
Usually answered in minutes!
×