At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
1992 Volvo would not start using the ignition switch
Hello, I own a 1992 240 Volvo the
car runs perfectly but just this week I'm unable to start the car using the
ignition switch when the key is turned on, all other electronic stuff works
fine. But the engine would not turn over to start. the only way i can get the
engine started is to bridge the starting motor terminals once it starts it runs
perfectly the ignition key is used to turn it off but it would not start it up
on it's own using the key. I recently installed a new
ignition switch and it is still not starting with the key. I await for your reply Thank you, Lee
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The problem has to be either in the fuel delivery system or ignition system respectively. U need to trouble shoot those two areas to locate source of problem. For example, if your fuel pump is not running no way your engine gets gas and runs. If not running, why? Is the motor bogus or is it not getting power? Coil(s)?, fuses, filters, switches in line, etc.
Basically you have to be a good thorough detective and leave no stones un turned.
Might want to pull the computer codes to see which sensor or switch
is malfunctioning. The computer is in limp in mode to keep it running and get you home. The codes should point you in the right direction.
On older types 240 there was some kind of antitheft system connected with the steering lock. Try to route a lead from the battery to the ignition coil and se if it starts.
I drove a 240 with a separate ignition switch all through high school.
It is a can shaped air flow sensro, in the plastic intake hose. To replace it all you have to do is pull the electrical connector, unscrew the clamps on the line on both sides, and switch out the sensor. Make sure you have the correct sensor, there were 3 different types used.
use a probe light and check the connectors on the back of the iginition switch first ,hold key in start position and check for a feed from switch.then if you have a feed work your way back to motor and check relay
It could be a number of things but must be diagnosed via computer code check. If you are unable to do so yourself, find a reputable Volvo mechanic. It could be the air mass meter, a bad O2 sensor or something related. Mine turned out not to be the air meter but a bad ground wire going to it. Didn't find out until $400.00 later.
If the dash lights go on when you turn the key to the on position then turn it to the start position the dash lights should go off. If this does not happen, your ignition switch may be bad.
Try a new engine rpm speed sensor. It is located at the back-top of engine block where it mates to trans. You will need to remove a single bolt (10mm socket or wrench). You may have to wiggle the sensor to lift it out. Another symtom you may experience, is when you are cranking the car to start, it will buck and act like it is out of time. Another possible component is the ignition power stage/amplifier.
×