Were is the fuel pump relay on a 09 charger - 2009 Dodge Charger

IN POWER DISTRIBUTION CENTER ENGINE COMPARMENT
CORNER GROUP OF SIX RELAYS 3 INSIDE AND 3 OUTSIDE
THE MIDLE OUTSIDE IS THE FUEL PUMP RELAY

IN POWER DISTRIBUTION CENTER ENGINE COMPARMENT
CORNER GROUP OF SIX RELAYS 3 INSIDE AND 3 OUTSIDE
THE MIDLE OUTSIDE IS THE FUEL PUMP RELAY

09 what ? Fuel pump , fuel pump relay , electrical circuit problems , anti-theft system problem not energizing fuel injectors .

There is none. The fuel pump is controlled by a relay and that is controlled by the ECM computer. Check pump, fuse, relay etc

Hi there try and bridge fuel pump relay power supply to see if pump activates .check fuel pump ground and power supply when cranking . Possible fuel pump or relay failure.Do check all fuses.

I think your fuel pump relay is bad as it activates the pump and thestarter . Also check the starter relay . It could be going bad.

honda fit. 09
the operators guide show the fuse boxes and usually relay names inside. look there yet? that is always first ofter checking for bad fuses
no symptoms posted, so cant guess, job or reason or whats up./
alldata.com
i looked but all 20 pages of fuel system have no name.
just page 1 to 20
too lazy to read them all.

hook up a to the obd and comand the ecm to prime the fuel pump if it doesnt prime its the ecm providing wires and relays are good

we dont have fuel pump relay exactly like ordinary relay of vios '09 this is called integraded relay w/c is built in fuse.. i have many times encouter like this problem not once or twice.. 10x i already doing all aspect or diagnose for this system but still de same problem.. its too much headache

no do not drill no holes wher the gas tank is.the bast way to drop it is to buy a syphon pump for $10 at walmart and get all the gas out. it is located on top of gas tank. to test a relay . take an old phone charger cut the end off that connects to phone wrap one wire to #86 and other to #85 on the relay terminals . it should click each time you connect the charger to terminals. if u have a multimeter use the continuity seting and check terminals 87 and 30 for continuity. it should only beep with power aplied to #86 and 85