Trying to get the remote to work on 1999 Crown Vic, I think the remote battery is down, also the dash light up by the VIN is flashing, key pad on door works with security code, car will start and run with the key, but the remote will not function as it once did - are there any issue in changing the battery inside the remote??
Remote needs to be taken apart either by a small screwdriver, or by finding the small tabs on the side and separating the two halves of the remote. Button cell batteries.
SOURCE: 1999 crown vic keeps getting air locked at the fuel rail?
check your fuel pressure
if you dont have enough pressure this will happen
when the fuel pressure is good the system will just push the air out through the injectors or the fuel return line
SOURCE: 1999 ford crown vic dash light running light problem.
Check all the bulbs at tail end for parking and brakes, test grounds and harness for trailer. Check fuses. clean batery terminals, Re instal head light swich properly and make sure all wires conect.
Vitally
Testimonial: "thank you for quick response will try all of your suggestions will re post if no luck."
SOURCE: 99crown vic wont crank put code in door lock
find the fuse fo the keyless enter and take it out and that way you will know if that the problem or something else give these websites a try www.autozone.com and www.alldatadiy.com cause the keyless enter will short out sometimes wish you the best of luck Michigan Man.
SOURCE: 92 crown vic - temperature guage on the dash is not working...
The temperature gauge sending unit is located in the front section of the intake manifold, just to the right of the alternator on the 4.6L engines. Got this from autozones repair manuals
86 views
Usually answered in minutes!
×