Have you replaced the fuel filter. also check the battery new cars use a lot of power and that could cause a random misfire code. if those are all good then check for a vacumm leak. you can do that with carb cleaner by running the vehicle and spraying around the intake manifold or vacumm lines and listen for a change in the motor
SOURCE: p134, p0141, po300, po130 and po135. 2005 Sunfire.
Given that most of the trouble codes are for the O2 sensor, I think I would change it. The multiple misfires could be because of improper fuel/air mixture caused by a bad sensor. Disconnect the negative(-) battery terminal then change the sensor. Disconnecting the negative(-) should reset the computer and allow the fuel/air mixture to return to default allowing the engine to start.
P0130 - O2 Sensor Circuit Malfunction (Bank 1 Sensor 1)
P0134 - O2 Sensor Circuit No Activity Detected (Bank 1 Sensor 1)
P0135 - O2 Sensor Heater Circuit Malfunction (Bank 1 Sensor 1)
P0141 - O2 Sensor Heater Circuit Malfunction (Bank 1 Sensor 2)
P0300 - Random/Multiple Cylinder Misfire Detected
SOURCE: 2005 chevy colorado runs rough and gets bad gas mileage.
Sounds like it needs spark plugs and wires, and a fuel system treatment.
SOURCE: po302 code,po301,po300
usually a p0300 is a random missfire code due to a fuel problem probaly bad gas , use some in tank fuel treatment such as techron or lucas injector cleaner, after adding fuel disconnect negative terminal to batt, to clear codes and see what happens
SOURCE: Rough idle
sound slike you may have unplugged or disconnected somethine else or the spark plug you put in is bad or inpropper gap
SOURCE: replaced battery on 2002 gmc envoy. now it goes dead when air is
You need to clean your throttle body, make sure to clean both front and back sides thoroughly.
442 views
Usually answered in minutes!
×