So my car has been making a whinning noise... took it apart and found out its my idel pulley, but my problem is that where it screws into the bracket, the bracket is busted. Its the bracket that also hold my tensioner pulley, alternator, and this idel pulley... my question is, what is this bracket called. i thought it was an alternator bracket but not having any luck find a part under that name... the bracket has 3 screws that screw into the engin and 1 that holds the alternator
SOURCE: can you find an engine diagram for an 02 chevy
That is the water pump bypass/heater hoses you have to get them from the dealer, they know the ones. They are plastic and you should replace both and make sure you get all the pieces out as they will break when removed.
SOURCE: replace power steering pump on a 99 tahoe
you have to remove the pulley get a PS pulley removing tool you will need it to put pulley back on
SOURCE: Chevrolet Equinox how to change the head light
Hiya
IF it's the headlight's light bulb you want to access to pull out old bulb and install new bulb, here it is:
You know where the 3 bolts that secure the headlight body on the frame, also pull out the 4 black plastic clips that holds the grille-it's located on the top grille brackets (it's close to the top radiator area)
When you pull out the clips, gently pull the grille away from the top frame, then pull the headlight body away carefully to allow your hand to gain access behind the grille/headlamp body, find the wire that connects to the headlight bulb, use your fingers to feel the plastic 'collar ring' around the socket and twist it counterclockwise (just like unscrewing a lid off the jar) and pull the socket out with the bulb.
This space is tight for your fingers so it takes patient to get the job done.
IF it's the ENTIRE headlight body you want to remove it off the equinox (since you mentioned you've removed the 3 screws) there's one more that still holds it down is the black plastic tab that's only accessible inside the fender! So to gain access under the fender, remove the plastic wheelwell liner part located underneath the front-left fender (driver's side) there's a small screw and few plastic clips you'll need to remove it to move the wheelliner liner aside to locate that headlight body's plastic tab on the fender frame, use a plier to 'unlock' the tab out of the hole.
SOURCE: My belt tensioner pulley broke at the bolt that
You should only remove the drive belt shield if you raise the car. Below are step-by-step instructions per the repair manual.
Drive Belt Tensioner
Removal & Installation
To Remove:
To Install:
SOURCE: My check engine light on my 2006 Chevy Equinox
I would bring it back to the shop that did the work. If the code is coming out as a problem with the evap system it is not abnormal for the system to take 2 or 3 days for it to read again.
293 views
Usually answered in minutes!
×