SOURCE: Hard to move Gear Shifter in a 2000 Dodge Intrepid ES
I had the same problem after my car went into a transmission shop for some service. This might be the solution, it was with my car. Check the transmission shift cable. When mine finally failed, it was filled with rust.
You may be able to simply lubricate it somehow with something like WD40, but I'm not sure if it would work. If all else fails, you can have the shift cable replaced, which is what I had to do with my car after driving it for 2 years with that problem. By then I had worn out and warped the shifter and had to replace that too, as well as drive it around for a week without being able to get the transmission into park.
Good luck! If you have to take it to a shop, just tell them that your shift cable is going bad and you want them to make sure.
SOURCE: 2000 dodge ram sport 4x4
check for bad connections on the back of the PCB panel under the hood (left side) they are prone to corrosion
SOURCE: 99 intrepid electrical problems
i have seen an ignition switch cause exact same problems you are having on 1 of these vehicles..needs to be replaced
SOURCE: 2000 Dodge Intrepid. Replaced battery, speedometer stopped.
YOU NEED TO HAVE ENGINE CONTROLLER AND TRANS CONTROLLER SCANNED FOR FAULT CODES..LOOK FOR SPEED SENSOR FAULT CODES(OUTPUT)OR VEHICLE SPEED SENSOR FAULT CODES..IF SO..AN OUTPUT SPEED SENSOR WOULD BE GOOD PLACE TO START..LOCATED ON LEFT SIDE OF TRANS..FARTHEST ONE BACK..SCREWS INTO TRANS..ABOUT 40 BUCKS AT DEALER..HAVE CHANGED LOTS OF THEM..IF DOESN'T HELP,LET ME KNOW WHAT FAULTS ARE PRESENT
SOURCE: how do you replace a coolant air bleeder on 2000 dodge intrepid
unscrew it out of the thermostat housing and screw a new one in. make sure cars not hot when you do this.
178 views
Usually answered in minutes!
×