If the system is turned on and the light stays on then you may want to check if they unplugged or possibly broke the wheel speed sensor when replacing the wheel bearing The system works by measuring the different wheel speeds to determine if the car is in a skid. If one sensor is no good this light will come on however this usually involves the abs light also coming on.
Hello there
First of all, with the VSA (Vehicle Stability Assist) light showing on the dash (marked VSA) it means that particular system has a problem or the push on/off switch located on the lower left portion of the dashboard and above the drivers left knee, has been pushed, turning that system off.
If you push the VSA button and the dash lamp goes out, then you're all set.
If the lamp remains on, you need to have the system checked by your Honda dealer or an independant shop who is experienced and knowledgable regarding this Honda system.
I hope this information is of assistance to you,
Randy Atchleyy
SOURCE: my vsa system indicator and
It's hard to said what it is without a VSA code, but the VSA system monitor the rotation of you tires. Check and make sure you have the same tire size for all four tires. If the tires are not spinning at the same ratio could cause the VSA light to come. It could be a bad sensor or even the VSA modulator itself. It's hard to said. Good luck
SOURCE: vsa light
My best guess is that it is a false trouble code when the trans was replaced. I would suggest taking it to any local shop with diagnostics the should be able to see what the code is and clear it. If it is from the trans swap after the code is cleared it should not come back on again.
SOURCE: VSA and ABS light indicator stays on
Please see my tip at http://www.fixya.com/cars/r6003525-abs_traction_control_lights . These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with model, year and engine info.
SOURCE: how do you reset blinking vsa light
Who did the work? The speed sensor in one of the new hubs could be bad or during the insulation one of the pins got damaged. I would suggest to look at ABS system, scan for any active code/s, take a look at live data and see if a relearn procedure is needed because of the installation of the new hubs. But you will probably find that the fault has to do with an ABS wheel speed sensor. Good luck.
SOURCE: vsa and abs lights on for 2005 honda crv
An often overlooked problem when the VSA and triangle light cones on is a clogged screen behind the oil filter mounting bracket and the end of the solenoid where it goes into head has multiple screens around it that have a tendency to get clogged. Remove these and clean gently till any caking or particles have been cleaned off.
Whenever this warning or any other stays on in the dash it is indicating that the systems control module has detected a fault, it then disables the system as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)
1,605 views
Usually answered in minutes!
×