Chevy 2500 epress cargo van rear vibration

SOURCE: how to change fuel pump in 97 chevy 2500 (cargo

You have to drop the fuel tank. It is inside. Hope the tank is near empty, remove the 2 fuel fill hoses, you have two straps, lower tank, remove 3 wire connectors, and several more lines. Please use an ac delco fuel pump module. It may come updated with a new wiring connector to fix the old ones problem. If it does, you have to rewire the van following the directions.

SOURCE: need a rear end diagram for 1995 chevy cargo van 2

if you are leaking gear oil through the tire you need an axle shaft seal there is also a axle bearing there unless it is a full floating axle which means the axle has a flange on the wheel end that bolts on. if you go to the chevy dealership near you go to parts and they can print you out a break down of the axle according to your vin number on the van

SOURCE: how to replace brake light in 2008 chevy express cargo van

You have to remove the upper applique to remove the tail lamp, it is the trim panel above the lamp. I think it is held in place by two nuts/bolts but not sure. You have to have the rear doors open to remove it

SOURCE: 2006 chevy 2500 express cargo

60psi cold / 30-45psi warm is ideal. I've seen (with that mileage) 45 cold/ 20 warm and that's acceptable - anything less start thinking about a new oil pump.