Fuse for the rear window defroster on the Dodge Neon

The fuse you need is in the fuse box inside the vehicle. It will be behind a trim panel in the end of the dashboard with the vehicle door open. Check fuses 6 and 7. Some features in a vehicle share a fuse. **Note** ALWAYS replace a fuse with one the same colour and Amp rating.
try this website it lists most fuses and which fuse box it is in.
https://knigaproavto.ru/shemy/en/chrysler/neon-chrysler/917-1999-2005-dodge-chrysler-plymouth-neon-fuse-box-diagram.html

check fuse get test light see if you are getting power to the lines in the back window

when you put the defrost on does the switch light up or show it is on. check also check the defrost tape on the back glass most times the summer causes it to come off the glass.

did u try looking at the fuses maybe a blown fuse

Yeah, I'd think it would have lines, too, unless some new way of doing it that I'm not aware of. Maybe the rear window was replaced with a window without the defrost option. There should be a small two wire connector coming out of the back shelf near lower driver's side of rear window. That would be the defrost connector to the window lines (that aren't there,lol).
Well, good luck with that! I think there are aftermarket kits for rear window defrost, though.

Yes, it could be the transmission control module or a shift solenoid in the transmission is plugged up or burnt out so it doesn't shift up.
---
Here is some info. about fuse locations on the 2004 Dodge Neon.

Circuit Protection Fuses Fuse block

Fuse block fuse location

Power Distribution Center (PDC)

PDC fuse and relay location

rear defrosters are an apllied film of semi metalic strips and if you get you windows tinted often the tint man accidentally nicks these strips cuasing the defroster to malfuction check for breaks in the srips

should be a 30 amp in the box under the hood shows number 8 on legend a 30 amp fuse

it may have a sencer my eagle talon had one look at the rear of the bumpr

This is what i found but you need one fob.

here is another way if you can get it done( i bevlieve) There is a box under the dash of your can it says keyless entry if you have the right box and the fab just plug and play.

Make sure you get the screws in the defrost vent there is some screws and then it there is snaps


http://shopping.msn.com/specs/keyless-entry-remote-fob-clicker-for-2004-dodge-neon-with-do-it-yourself-programming-requires-1-wor/itemid1124228415/?itemtext=itemname:keyless-entry-remote-fob-clicker-for-2004-dodge-neon-with-do-it-yourself-programming-requires-1-wor