I just traded my 2000 towncar for a 2006 lincoln ls .only thing wrong is serpentine belt cracking. good ol AZ heat'. just replaced serpentine on my old lincoln but when I went under hood to see what mechanic saw its a whole new ballgame. I cant seem to find any local stores that carry the Repair manual.Can you tell us how to replace serpentine on the 06 lin ls.thank you
It's old question, you might find it out already.
If not, here is pictures and diagrams.
It might be two different routing.
Mine is limo which has two alternators.
try to see which is yours.
(red was mine with two alternators. original is black in diagram)
also you may know how to loosen serpentine by insert and turn 3/8 drive ratchet (just ratchet without any socket) to tensioner pulley if not, here is picture (I use 3/8 ratchet + pipe).
Picture was taken after 2nd alternator removed (around upper hose)
SOURCE: Replace brake pads and rotor on Lincoln LS 2000 front wheels.
new rotors and new brake pads ...
...full job would include loaded calipers with all new hardware ..if you pay attention to disassembly you will not need a service manual necessarly..all is logical and straightforward...but you are dealing with safety so be sure you are good before taking a drive ...good luck
SOURCE: 2000 Lincoln ls overheating
There is a hose on the side of the coolant resevoir that has a straight blade screwdriver fitting in it. Open the fitting and this will bleed the heads on the LS. Without opening this you will never get the air out of the head, trust me.
SOURCE: lINCOLN ls bRAKE lIGHT REPLACEMENT
One of 2 ways.......
#1) mounting screws on the exterior of the brake light lens.
#2) in the trunk behind the carpeting, usually this is the easiest way. either way the bulb is held in by a twist lock bulb holder.
GGBMDB
SOURCE: REPLACE HEADLIGHT ASSEMBLY IN 2000 LINCOLN TOWNCAR
Open the hood and make sure the car and the lights are off.
Remove the plastic protective cover.There are 3 knobs,turn halfway and pull.Put aside and out of the way.
Remove the three pins that are holding the light assembly in place.These are flat rods with a little bend at the end.
Twist and un-plug the lights,now you can remove the whole lens.
The light bulbs can also be removed and replaced from this point.
Make sure all the bulbs are working before you put it back together.
SOURCE: 2000 lincoln ls bad ball joints! should i replace whole knuckle or just ball joints
yes you can buy just the ball joints
Fig. Serpentine accessory drive belt routing - 3.9L (VIN A) engine
Please feel free to get back to CONTACT US clicking over image diagram. Also keep in mind that your feedback is important and I'll appreciate
your time and consideration if you leave some testimonial comment about
this answer.
Thank you for using Fixya, and have a nice day.
555 views
Usually answered in minutes!
×