Question about 1997 Ford Taurus

Open Question

1999 ford taurus line removal - 1997 Ford Taurus

Posted by Anonymous on


6 Suggested Answers


6ya staff

  • 2 Answers


Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017



  • 3 Answers

SOURCE: 1999 ford taurus emission reading p0171 and p0174

just tune up ur car periodicly, clean filter. clean ur sparkplug.

Posted on Jan 16, 2009



  • 1986 Answers

SOURCE: How remove the door panel?

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

nuckle bustr

  • 474 Answers

SOURCE: Need diagram for 1999 Ford Taurus serpintine belt

it sould be located under the hood on the radiator shroud area

Posted on Oct 03, 2009

Ted Schore

  • 7353 Answers

SOURCE: 1999 ford Taurus serpentine belt routing diagram

Posted on Nov 10, 2009

Nick Wachter

  • 123 Answers


You must mean the catalytic converters? There are two. One for the front manifold and one for one for the rear. They also call this set ( because they come already wielded together with a pipe in between ) The Y pipe. The catalitic converters are about the size of a half flat football and are the first thing the exhaust pipe leaving the ngine come to. The front one is between the engine and the radiator and the bottom with the y pipe its connected to travels from the front cat across the bottom of the oil pan where it connects to the rear catalytic converter witch is a lot harder to get to. Hope you don't need to re;place one of them they come together as 1 unit and they are around $1100 to buy and that's just the part not the installation. Plus there are 4 O2 sensors that go with it. 1 above and 1 below each catalytic converter that are about $100 each. I hope this info helps you out

Posted on May 29, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Ford Taurus 1999, v6 3.0l, 24valve how to remove crankshaft pulley?

1999 Ford Taurus Workshop Repair Service Manual PDF Download

for better result of your problem contact the reliable-store they have the best service manual

Oct 12, 2014 | 1999 Ford Taurus

1 Answer

How to remove the water pump drive belt on a 1999 ford taurus dohc 6cyl

here is a video for the sohc motor is it about the same way

Jan 27, 2013 | 1999 Ford Taurus

1 Answer

1999 ford taurus anti-brakes actuate when brake pedal is applied. since new brtake line was installed

make sure there is no air in the system then look closely where the line was bleed to see if there is anything bent or disconnected with the abs sensor.

Nov 02, 2011 | 1999 Ford Taurus

1 Answer

What type of break line Ford Taurus 1999 has ? and how much it will cost?

What are your vehicles problems?
What is the question your asking?
No brake tubing is avail for any vehicle

If you need to replace brake lines, you have to buy
tubing,cut,bend,flair and fabricate your own

Dec 23, 2010 | 1999 Ford Taurus

2 Answers

Instal 1999 ford taurus fuel filter

along the drivers side under the car

Nov 03, 2010 | 1999 Ford Taurus

1 Answer

How to change fuel pump on 1999 ford taurus?

The fuel pump is in the tank, You will have to drain the fuel and disconnect the fuel lines (will need a fuel line release tool, they are sold at most auto parts stores) and the filler hose. Then remove the fuel sending unit out of the tank.

Oct 26, 2010 | 1999 Ford Taurus

1 Answer

I have broken motor mount in my 1999 ford taurus.

Here's a link that may help you.

Jul 23, 2009 | 1999 Ford Taurus

1 Answer

A solonoid passanger side firewall 1999 ford

I believe that is the EGR solenoid

Jul 06, 2009 | 1999 Ford Taurus

2 Answers

1999 ford taurus

check the fuel pump itself.. if no fuel going through lines... injectors won't work.

Aug 16, 2008 | 1999 Ford Taurus

Not finding what you are looking for?
1997 Ford Taurus Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides