[please give me detailed info on
how to replace clutch
Ive been told i need to disengage the steering shaft and remove driveshafts to allow front suspension crossmember to be removed
can i leave powersteering and air con pipes in situ
and is it possible without a two poster ramp
unfortunately in do not have access to a garage
This job is REALLY hard to do on the ground. You'll have to jack it up high enough to remove the transmission and move it out of the way. You'll also need a top end engine support stand to hold it in place safely while your remove the engine cradle. If you don't have tall jackstands and an engine support, don't even think about doing this on your own. It's simply not safe.
SOURCE: Horn not Working, Ford Fiesta zetec 55
its most probably the clock spring which you need to take the steering wheel off to fit
SOURCE: Power Steering
if it's the low pressure side i'm sure a mechanic can replace just the broken part. if it's the high pressure side, best off just to get a new hose. if not, the hose is likely to leak again on the high pressure hose if the unit isn't replaced.
SOURCE: to replace front axle shaft seal on 1995 f-350 4x4
Most oil seals are just pressed in from the outside. I've removed oil seals by using a small Allen wrench to hook the seal and pull it out.
260 views
Usually answered in minutes!
×