Need belt diagram for A 1995 Dodge V10

The 3.3 L Caravan engine does not use a timing belt.. It is timing chain set up. What belt are you talking about that broke?? The serpentine belt that drives all the accessories??

do you have a autozone store nearby if so the belt is available for $30.99 in the duralast brand part#987k6 and a sales associate can print you a belt routing diagram for these specific vehicle hope this helps out

should be on the underside of your hoos or on your rad support

The belt diagram should be under the hood on a white sticker. Located on the radiator cover.

have diagram for belts need engine size and 8th digit of your vin number and email address to send to

My apologies for the delayed response. I am going back and answering questions that were never answered.
Click on the following Link. It has all the Diagrams for the Timing Belt you will need.
Before Clicking, let me know if this helped.
Again my sincerest apologies...

http://www.2carpros.com/car_repair_information/year/1995/make/dodge/model/neon/1995_dodge_neon_timing_belt_diagram_marks.htm

From 1991-1995 the same belt is used. Here is the diagram and also the tension you can locate it for tightening adjustment.

You can find one at autozone.com, you may have to sign up for a free account, but you can view the job diagram there. It looks like for a 6 cylinder, there are two belts, one goes from the crank pully around the water pump then the alternator, and the other goes around the crank shaft then the power steering pump and then the air compressor pully. The power steering and air is a "v" belt and the other is a ribbed serpentine belt. they both just wrap around no wierd routing. the only thing I do not see is the idler pully or tensioner pullys.

The Autozone picture must be from an older Dakota 3.9L. My Dakota 3.9L belt routing is as shown. To remove the belt put a wrench on the tensioner pulley fastener (fastener in center of pulley) and rotate it clockwise. This will pivot the tensioner loosening the belt, Remove the old belt and install new one per the routing. Check to make sure the belt is sitting properly in all pulleys

The belt routing diagram is located on the top radiator cross member by the hood latch. You should see it when you open the hood. If it is not there, all Chrysler, Dodge, and Plymouth minivans, from 1993 to at least 1999, used the same 3.3L engine setup, so find someone with one and look for the diagram where I described.