My car got the keys stuck in the ignition. Once i was able to get them out the car was still running. How do i fix this?
SOURCE: 2006 Ion 2, Key is stuck in the ignition and wont move.
get a new ignition lock cylinder. they usually have simple instructions with them on how to replace
SOURCE: chevy cobalt LS 2006 key stuck in ignition nothing will come on
Have you checked the battery?
SOURCE: 2006 Ion 2, Key is stuck in the ignition and wont move.
In my case, out in 29 palms california, I've noticed heat expands the bolt which probably does the same to the tumblers. It would only happen in the afternoons when the steering column was in direct sunlight while I was inside working for hours. Everything would be fine, then when I left and got to home or destination, the bolt would not return home to shut off the car. I saw a suggestion in another website that said if you remove a small access door below the wheel, there is a plunger you can hold and set it back to home, but hello, the bolt and tumblers at this point have expanded from the heat to a position not resettable but a simple plunger, or resetting the cars computer for an electronic release (the initial problem is the cable down there with the plunger does not always send the signal that "I am in park." It thinks its still in Drive, so it won't let it return home.
My suggestion is to get one of those canned air for electronics, flip it upside down and freeze down the bolt, tumblers, and all metal involved in the problem here (you can see most of it once you remove the upper and lower parts of the steering column) and let the metal retract, hopefully letting you move it back to home (careful, dont snap the key). Grease the key with a small amount of motor oil to help (which you should do from time to time anyways with this vehicle).
If you are stuck and can't do that, or afford repairs at this moment, behind the wheel, below the ignition (you will be reaching back mostly behind, and there is a small plastic clip with colored wires that snap into place). Remove this when you want the car to turn "off." Removing this cable and letting it just hang there until you come back later will remove all electrical potential that is normally removed when you turn the key all the way home. It's annoying, and looks like you are hotwiring your car, but its working for me right now until I can fix it. This, is of course, assuming you are like me and the bolt is stuck fully forward, one click back from Start).
SOURCE: key stuck in ignition but it will turn, and
you most likely have a bad key switch cylinder assembly. you can try to spray wd40 solvent into the switch before you have the switch replaced,but sometimes it's a switch replacement that repairs the problem. have you inspected your ignition key to look for damage to the key itself? try a spare key to make sure it's the key,and not the key switch. you can also try turning the key while turning the steering wheel at the same time to get the key to work.sometimes the switch locks when parked in a bind,such as on a hill,or against a curb and so on. try this 1st before you have the ignition switch replaced. AAA auto club,if you're a member covers part of the replacement costs for a replacement switch also. you may have coverage through a cell phone also.one more thing to try, if you have a tilt steering column,try to reposition the steering wheel to see if you can get the key to turn. remember never force it enough to break your key off into the switch! thank you for choosing fixya.com!
82 views
Usually answered in minutes!
×