My vehicle will not crank and will not start. I have changed the ignition switch the neutral safety switch and even bought a new battery. as soon as I insert my key the 10 amp fuse inside the car burns I don't even have to turn it into the on position. I don't know what else to try besides the starter and solenoid. does anybody know what it might be? I tested where the fuse goes in and im getting 12 volts into it which I think is too much what could be causing it?
SOURCE: Not starting
did you install the battery backwards?if so,you might have caused some serious issues
SOURCE: I do not have a
If you find a red key flashing it means that the car has got antitheft system fitted. Is your car alarmed? What about the key, has it got a remote?
SOURCE: 2000 Mazda MPV-DX 2.5L V6 won't turn over just clicks.
yes it could be the starter next time it won't start give the starter motor a tap with a hammer or wheel brace also check where the small blade connector is there should be a fuse in line could be the problem hope this helps regards Jim
SOURCE: i have telstar tx5 ghia
Hi
Easiest test is to reconnect jumper cables and switch lights on, if these work and no noise AT ALL from starter, NO clicking at all then could be the jumper cables are too light like most are. Try 2 sets of jumper cables. Ensure that the cables are correclty applied, Red to Red and the black is the last connection to a good steel part on your engine, NOT the battery.Always ensure the car being used to jump from is running at all times while cables are connected.When it starts remove this one FIRST also.
Cheers cbacer
184 views
Usually answered in minutes!
×