Hand break light wont work on Mitsubishi triton ute 2001

SOURCE: 2008 Mitsubishi Triton ute ,colour white

I've solved the problem.Went to my local auto parts shop.
Thanks anyway

SOURCE: coolant leaking from behind timing belt cover.

Hi, This will be more likely to be the water pump.
hope this helps
George.

SOURCE: I need to buy a new or used bumper bar for a 2005

Check with a wrecking yard that specializes in foreign vehicles--most will run a nationwide search if they don't have it themselves.

SOURCE: how to replace cluch fluid in mitsubishi triton

On the slave cylinder will be a bleed port, remove this fitting (port), remove the fill cap and let the fluid drain into a pan, will not take long if you help by pushing on the clutch pedal a few times.

SOURCE: how do i tighten the handbrake on my mitsubishi

Hi,
Inorder to tighten it you need to check to see if the side that is not holding if the primary shoe that the handbrake cable pulls on. If not then you may need to adjust the adjuster at the shoe. It may be too far retractor so when the handbrake is engaged, the shoe is not coming out far enough to grab the inside of the drum. There is most likely nothing wrong with the cable. You just need to adjust the shoes. When you pull the wheel off and inspect the shoes, you will see if they are not worn. To use the adjuster, pull see it will be near the retainer spring, the spring will connect from the top and bottom of the shoes to retract them. On the top side, where the upper spring is will be the mechanical adjuster, where you can adjust out the shoes to make them grab accordingly when engaged.

Let us know if you were looking for something more else please accept the suggestion.
Thank You for contacting Fixya.com