The power window motor works, but the window is not connected.
SOURCE: remove door panel
undo screws then use a small screw driver to pull out clips, but gently. It is the same as most cars.
SOURCE: Power window does not work
you need to buy or make a clip removal tool. it looks like a sturdy 2 prong fork to pry off the plastic clips.this id whats holding the interior panel and some screws holding the door opener
SOURCE: need to pull door panel off to replace power
There are 2 screws holding the window switches to the door and 2 screws for the door panel, one is in the pull handle, the other behind the window switches. Remove these screws and using a trim remover(hopefully) work around the sides and bottom of the door to pop the plastic retainers out of the door, push in at the top of the door panel and push up from the bottom to release the top retainer.
There is more to changing the motor than you may think. Steel cover has to be popped off and reused, so be careful.
SOURCE: How to remove interior door panel on 2002 chrysler t & c???
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
SOURCE: How do I remove the driver's door interior panel?
1, Disconnect the cable from the negative side of the battery.
2. Pry the courtesy light from the panel, and disconnect the wiring connector.
3. Remove all panel retaining scews. Most are covered. Look carefully for them all.
4. Remove door switch panel and switch assembly.
5. Memory Seats/Mirrors? If so equipped use a small flat pry tool ( I use a upholstery tool) and remove the mirror/seat switch and disconnect.
6. Using the pry tool: satrting at the bottom: pry the panel away from the door. Continue on the sides.
7. Lift Up and off the top of the window sill and locking knob.
8. Disconnect and remaining wiring connections.
9. Disconnect the door handle rod. Unsnap the plastic keep off the rod, and remove "L" shape out of plastic keeper hole.
10. Note how the waterseal (plastic/rubber) is placed and what wiring connections come out what openings.
11. Remove the waterseal.
12, Most of the Power Window Motors will actually come with the rails and/or the cables attached.
13. The rest is pretty much remove the old motor and cables and replacing them with the new one's. I have faith the rst you can figure out.
Let me know if this helped or not or if you need any additional instructions let me know at fixya.com
Testimonial: "Terrific help, Thanks much."
Visit The Official RAM Truck Site To View Photos Of The New RAM 1500.
www.RAMTrucks.com/1500
211 views
Usually answered in minutes!
×