Bought an import carb engine changed it too injection wit my intake nd injectors but doesnt wanna take start.Wen i pour fuel from the front pipe its starts but cuts off wit a heavy rumbble
SOURCE: Help w 1994 chevrolet truck
disconnect the batt. is your fuel pump running check fuse listen for it
SOURCE: 2000 vw cabrio runs normal and shuts down, takes 5
On some models, the Engine Control unit has a power supply relay. These relays some times get internal dry solder points. After driving for some time the the solder will get hot and separate. When it cools down it makes contact again. You will have to replace this relay or open it up and re- solder the solder joints. The relay is usually located on the main relay station in position 3. the relay station is located behind the right dash panel.[right hand drive vehicles]. You may need to refer to a manual for your specific model to find the exact location of the relay.
No idea offhand to be honest i would need my head under the bonnet to know what wrong .could be anything from the gauze filter in the fuel tank on the bottom of the fuel pump becoming chocked up and leaving the car allows it to drop away to a faulty pump overheating or the contacts ,maybe even a ignition module overheating ,Best advice is ask a local mechanic to have a look for you as normally these early opel corsas with the 4 cylinder engine are bullet proof they are even valve free if the timing belt snaps .
SOURCE: When driving suddenly the engine cuts out.
nissan navara YD25 engine when you start engine cut off off after few minutes
161 views
Usually answered in minutes!
×