Ford windstar van, 2003

Too many possibilities and limited information. Does the engine still run and the car does not move? Or is the engine not running so that the car stopped? Repost the question with additional information.

The abs is dirty on the inside and needs rebuilt

The switches inside need to be replaced they are hanging up do this now before you ruin the clutches it will go back to normal shifting and work fine change all pressure torque lockup and shift switches diy for about 125.00 with fluid filter cost and back to normal shifting and a happy van and crew make sure vans not running hot burning fluid otherwise will happen again high temp burned fluid damages switches ability to work

Given the vehicle,age & all the terrible
transaxle problems on a windstar & vehicle
it replaced

Your transaxle has failed

Having once owned a trans repair shop

Get rid of it & never buy another van type
vehicle,any brand

How do u rest and keypad pine to a van or get one for my van it's a 2003 windstar Ford van

Those transaxles are not good, and you
may have on that is 8 years old and original

It has passed it's service life and will need to
rebuilt.

All van type transaxles are a problem
and don't do well

Very common on this make and model trans, pump drive splines inside torque converter strip out and pump is not turning, Most times there is no damage to pump shaft. Remove trans and remove torque converter, inspect the splines at the very bottom of the hub hole. If stripped out inspected pump shaft splines which are the smaller center splines coming out of trans, if ok replace torque converter and re-install trans, change out fluid, clean any metal from magnet and replace filter, fill with fluid and verify proper operation.

pump went out on transmission

digital transmission range switch

Need to check your trans fluid first. do this with van running and engine warm.