- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
You mean you release the handle to open the gas door but the gas door is not open...? A: If so. Ask a helper to pull the gas door release lever and hold it. Now you need to manually open the door by hands. The spring load or clip that push the door open might be bend or broken. If so fix it or replace new one.
Some cars from these company's have security device on the gas doors. Some cars have to have both front doors unlocked before the gas door will open and some cars have a panel in the trunk with a rope or a lever behind them
have someone use something to pry it open while you pull on the lever it looks like the spring is broken or rusted off. in case you have a broken cable you can remove cable from inside trunk.
Have someone pull the gas door release. With a credit card, or something like it, popsicle stick, nail file, etc, insert it at the side of the door that opens, not the hinged side. While your assistant is pulling the lever, see if you can manually pull the door open. If it opens, you have a broken fuel door spring. Toyota parts depts sell them for 3 dollars. The spring is there to "pop" the door open, when you pull the lever. If it is broken, and they break rather often, it needs replaced.
Try removing the plastic lever handle to see if it will let you push
the lever further towards the floor resulting in more tension on the
(hopefully not broken) cable.
Take a plastic knife like you would get at Wendy's (or anything you can think of that would work better) and wiggle it in the center of the right side of the fuel door. You're trying to depress a trigger and pop it open. Forcing can bend the inner latch but it can be bent back. After you get it open you'll need to do some adjusting or diagnose if the cable is broke. Even though it's the same lever, it's two cables.
yeah i had the same problem and i felt really dumb when i took a closser look. if the car is locked, any of the doors, there is a pin that wont let anyone open it and siphen gas out of it.
Good luck Joe
If the lever itself is broken remove it it will have a cable attached to it. unhook the lever from the cable and pull the inner cord of the cable with plyer's or simular. If the lever is'nt broken it may be stressed so follow the same process. As to removing check arround the lever for screws if no screws the lever pivets on a pin gently tap out the pin with a small punch and hammer if you havent got a suitable punch then file or cut the point of a small nail.
I had the same problem. My gas door wouldn't open when I pulled the lever. My boyfriend was just messing around with my car one day and he connected a medium-sized spring to the bolt on the lower right corner...below where the gas cap goes. Now the door opens automatically when the lever is pulled. Hope this helps.
More than likely the metal spring on the inside of the gas door is broken where the plastic attaches. Have someone hold the fuel door lever in the release position while you gently use a flat head screw drive to open the door. The part should cost you less than $10 at Toyota.
×