Flasher relay won't stop

If I am not mistaken, these have 2 separate flashers. One for the turn signals and one for the hazards. If memory serves correctly, the turn signal flasher is square and the emergency flasher is round.

Had simular problem with wife 2000 Jeep Cherookee.
My signal light were not working at all.Check flasher relay under steering colum

the flasher unit is probably worn out.there is a bi-metalic metal strip that gets tired and won`t expand and contract making the clicking noise you hear when the signals are in use.it stops expanding and contracting causing the flashers to stop working.change the flasher unit but make sure you changing the one for the signal flasher and not the hazards flasher as they look the same.to know which one turn on the hazards and look for the other flasher that is not making a noise as this will be the one for the signals.

Change the flasher for the turn signals located under the dash on the driver's side. Check bulbs for continuity or lightability.

try replacing the flasher...

did you replace the turn signal flasher or the emergency flasher? turn on the emergency flasher lights and pull that flasher if they quit working you changed the wrong one.

A flasher would not cause this problem, It's in the trun signal switch, it needs to be replaced

the flasher is right below the radio,under the dash .it take 3or4 screws to take off panel.both flashers are under there.one for your 4 ways,and one for your turn signal.if your four ways work you can fill the flasher to determin which is witch. mine the four ways was on the left,turn signal on the right.they are not in the back of glove box.ther is apanel there with three relays but not for your turn signal.thank u gm jim.u helped me find them.

the flasher relay is a aluminum cylinder relay on the fuse panel. It's the shiny one.

please check your flasher relay. it is normally a three prong relay box.


tnx 4 using fixya,

drcool