Electric windows not working

Do the individual door switches work their windows? If so, it would be the driver's side door switch, the master switch, that is bad.
The fact that one window works off the driver switch means that power for the windows is at least getting to the master switch, and that the ground for all power windows is good. If the other door switches work, it is just the master switch, not a wiring problem.

open switch up on driver side . keep in mine there is springs in there, get all part in right place before putting back together. check pronges for trash

The relay operates all the windows. The drivers door switch is the master and has to be connected for the rest to work. It sounds like you have a bad motor or a bad connection on the motor in the drivers door.

if not working from drivers or passenger side you need to remove passenger side door skin, with a test light check for power at the motor? If you have power at the motor and the motor is grounded you need a motor. If you dont have power and ground then you need a switch. This can be tricky sometimes the passenger switch is good and the problem is in the drivers side switch which is the main controller.

coulb be the control switch on your panel you can take the door panel off and check for loose connections and try to test for continuity. if you dont know how take it to a shop and have them diagnose the electrical. im quite sure it the switch that burnt out

Look between the drivers door and the car at the hinge ends.Look at the tubing joining the door with the car,and pull it back to check the connection at the plug.You may have to go inside the car and pull the kick panel off,and find the plug to the harness,and check for bad connection there,Also check the ground on the doors.I hope this helps,but a test light would help if you had one to test voltage on both sides of the harness plug.And test the voltage at the motors,and switches.

try to take the passenger side and hook it up to the drivers side then you will know if its a fuse or the window switch it self.

if not electric, remove the screw in the end of the adjustment lever inside the car, remove the cover, undo the three bolts & it should pretty much fall off. If its electric you may have to remove the door panel 1st to access the plug. To remove the door panel carefully remove the inner door opener surround (it will either have a screw in the middle or be clipped on) if its clipped on be very carefull, they break. remove the bungs & screws holding the inner door handle on & possibly the elec window switch or winder if its not electric (small circlip behind base of winder, use hook or small screwdriver) remove any other screws you can see. CAREFULLY pull on the door panel popping the clips behind bit by bit.

is it electric windows? if it has electric windows does the passenger window roll up using the switch for it on the passenger door panel? if it works on the passenger door panel and not on the driver's door panel , then your switch on the drivers door panel is bad... replace it.

hi there i had the same thing happen due to the door is loose. when u open the door there is a catch which in it as it did not grip properly to the metal bracket