VW Polo 2002 1.2 12v AZQ code.Engine cutting out, rev engine doesn't return to idle correctly, engine code p0106 ref Map sensor implausable signal. new Map sensor fitted and basic setting done. throttle body cleaned, new spark plugs. vehicle better but not perfect, any ideas.
Hi, I have a 2001 polo 1.4 mpi it lackes power when you hit a hill it just dies, It has had new cat, fuel filter, fuel pump and throttle body, but is still the same it just dose not want to give me full rev's?
Hi had a run on these .there is an issue with timing chain and tensioner.it jumps a tooth or two and runs like cylinders are down.done another one today.there is an modified timing kit available from vw.check chain timing you need locking pins as no timing marks anywhere,mine cost about 35 quid
I have a vw passat 57 plate 170 bhp, and a fault that has shown to be manifold pressure sensor intermidiate is this safe to drive ,, car runs fine but will it be ok to continue >?
8,939 views
Usually answered in minutes!
could you please explain what an "admission system" is, i've personally never heard of that expression. if you mean air intake then i have already done that with brake cleaner spray.
hi there,
I have exactly the same problem with my 2003 polo,its driving me mad.Ive taken it to various local garages and no one has been able to sort the problem.
I also have similar problem, car is running sluggish and when idle engine light began to flash and the car began to shudder. I have a 2005 1.2 12v 64bhp polo, and the engine management light has now came on and i got a diagnostic test done indicating 2nd cylinder not firing properly. I don't the code but the guys at the garage tried new plugs and i am now going to try a fuel injector to see if this solves the problem.
I've had the same problem with my 2003 polo. The garage I took it to also thought it was the 2nde cylinder and replaced it (apparently needed to be) but the problem continued. Eventually, it was diagnosed as needing a new Map Sensor. Don't know how much it's going to cost as they've asked me to drive it for the next few days. Car has been in garage for 3 weeks before being diagnosed however, after getting it back today it seems to be running find although the steering is now stiff!!! I give up
I am having the same issue with my 2001 Galant Mitsub. I changed the plugs, MAP sensor and checked the Throttle senor. I disconnected the MAF from sensor and it runs when reconnected it cuts off.
me too.. annoying as hell!! anyone figured it out yet
×