SOURCE: my 1997 gmc sonoma
This the problem with IAT bad inlet air temp (IAT) sensor.Get it replaced....................
SOURCE: what is the firing order on a 2000 4.3 gmc sonoma?
i dont know how they got it....i was just told that they got it......MEN!!!!
SOURCE: 2000 GMC SONOMA GUAGE CLUSTER HAS NO POWER -TRUCK
Very good possibilty usally you can smell around column near ignition switch and it will smell burnt.
Testimonial: "THANK YOU"
SOURCE: Replacing heater core in 2000 GMC sonoma. Dash is
If the dash is removed you've saved about 9 10ths of the job endurance. Look around, what you believe to be, the perimeter of the heater box. I cannot, and no one else can, tell you exactly where the bolts and nuts that mount the heater box are. Therefore you must viually sixe the box and check outide in the engine compartment and inside under the dash for the mounting bolts.You'll want to start by removing the heater hoses. Then starting at the passenger side engine compartment look for a group of 10mm or 7/16ths nuts retaining the housing and remove them. Do the same inside. The housing is usually held together with screws or clips, it changes year to year. Keep a log or pix of the wires and cables and hoses(vacuum) that are connected to the housing for reassembly. You'll need to "roll" the box out from under the dash depending on how much of the dash has been removed. The core is easy to spot for is has two hoses sticking out, and, is encircled with clips or screws . Also make sure you remove the bracket around the two entry hoses if it has one. Thank you, Dana
215 views
Usually answered in minutes!
×